enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bar stock - Wikipedia

   en.wikipedia.org/wiki/Bar_stock

   Bar stock, also (colloquially) known as blank, slug or billet, [1] is a common form of raw purified metal, used by industry to manufacture metal parts and products. Bar stock is available in a variety of extrusion shapes and lengths. The most common shapes are round (circular cross-section), rectangular, square and hexagonal.

3. Aluminum electrolytic capacitor - Wikipedia

   en.wikipedia.org/wiki/Aluminum_electrolytic...

   Thus, the dielectric strength also influences the size of the capacitor. However, due to standardized safety margins the actual forming voltage of electrolytic capacitors is higher than the rated voltage of the component. Aluminum anode foils are manufactured as so-called "mother rolls" of about 500 mm in width.

4. Blanking and piercing - Wikipedia

   en.wikipedia.org/wiki/Blanking_and_piercing

   This allows for complex shapes to be formed in sheet metal up to 6 mm (0.25 in) thick using simple tools. [4] that is essentially a small punch and die that reciprocates quickly; around 300–900 times per minute. Punches are available in various shape and sizes; oblong and rectangular punches are common because they minimize waste and allow ...

5. Stamping (metalworking) - Wikipedia

   en.wikipedia.org/wiki/Stamping_(metalworking)

   Stamping (also known as pressing) is the process of placing flat sheet metal in either blank or coil form into a stamping press where a tool and die surface forms the metal into a net shape. Stamping includes a variety of sheet-metal forming manufacturing processes, such as punching using a machine press or stamping press , blanking, embossing ...

6. Machine press - Wikipedia

   en.wikipedia.org/wiki/Machine_press

   A stamping press is a machine press used to shape or cut metal by deforming it with a die. It generally consists of a press frame, a bolster plate, and a ram. [5] Capping presses form caps from rolls of aluminium foil at up to 660 per minute.

7. Die (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Die_(manufacturing)

   A metal cup with a detailed feature at the bottom is an example of the difference between formed and drawn. The bottom of the cup was formed while the sides were drawn. Extruding: Extruding is the act of severely deforming blanks of metal called slugs into finished parts such as an aluminum I-beam. Extrusion dies use extremely high pressure ...