Search results
Results from the WOW.Com Content Network
SAE J1269 and SAE J2452 performed on new tires. SAE J2452 is a standard defined by the Society of Automotive Engineers [1] to measure the rolling resistance of tires. [2] Where the older standard, SAE J1269, produces measurements of rolling resistance under steady-state (i.e. thermally equilibrated) operating conditions, SAE J2452 produces measurements during a transient history of speed that ...
Rolling resistance, sometimes called rolling friction or rolling drag, is the force resisting the motion when a body (such as a ball, tire, or wheel) rolls on a surface. It is mainly caused by non-elastic effects; that is, not all the energy needed for deformation (or movement) of the wheel, roadbed, etc., is recovered when the pressure is removed.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
SAE J1269 is a standard test defined by the Society of Automotive Engineers [1] to measure the rolling resistance of tires under conditions of thermal equilibrium. [2] [3] SAE J2452 is an alternative procedure for measuring rolling resistance under conditions similar to a vehicle coastdown event, where the tire is in a roughly isothermal condition (but not thermal equilibrium).
Low rolling resistance tires are designed to reduce the energy loss as a tire rolls, decreasing the required rolling effort — and in the case of automotive applications, improving vehicle fuel efficiency as approximately 5–15% of the fuel consumed by a typical gas car may be used to overcome rolling resistance.
Rolling resistance is the main key factor in measuring the energy efficiency of a tyre and has direct influence on the fuel consumption of a vehicle. A set of tyres of the green class "A" compared to a "G" class can reduce fuel consumption by 9% [3] of a passenger car; even more for trucks.
In current vehicle simulator models, the tire model is the weakest and most difficult part to simulate. [2] The tire model must produce realistic shear forces during braking, acceleration, cornering, and combinations, on a range of surface conditions. Many models are in use. Most are semi-empirical, such as the Pacejka Magic Formula model.
When a wheel is set up to have some camber angle, the interaction between the tire and road surface causes the wheel to tend to want to roll in a curve, as if it were part of a conical surface (camber thrust). This tendency to turn increases the rolling resistance as well as increasing tire wear. A small degree of toe (toe-out for negative ...