Search results
Results from the WOW.Com Content Network
An amateur radio repeater system consisting of a 70 cm repeater and a 2-meter digipeater and iGate. Coaxial cavity RF filter at 2 meter repeater An amateur radio repeater is an electronic device that receives a weak or low-level amateur radio signal and retransmits it at a higher level or higher power, so that the signal can cover longer ...
A radio repeater is a combination of a radio receiver and a radio transmitter that receives a signal and retransmits it, so that two-way radio signals can cover longer distances. A repeater sited at a high elevation can allow two mobile stations, otherwise out of line-of-sight propagation range of each other, to communicate. [ 1 ]
Repeater equipment: GMSK Node Adapter - these devices are hardware GMSK modems with firmware to take D-STAR protocol frames over a USB cable and provide the necessary logic and GMSK modulation to control a simplex node or a full duplex repeater. One repeater that is easily adaptable is the Kenwood TKR-820 as documented by K7VE. [27]
Packet repeaters, called digipeaters, form the backbone of the APRS system, and use store and forward technology to retransmit packets. All stations operate on the same radio channel, and packets move through the network from digipeater to digipeater, propagating outward from their point of origin.
In a simplex system, the 5-tone just opens the speaker of the desired partner. In a repeater system, another CTCSS or tone-burst or 5-tone is needed to activate the company's repeater, depending on the systems design. If the called radio is within reach of the sender, it answers the incoming call with its stored receipt tone.
The Internet Radio Linking Project, also called IRLP links amateur radio stations around the world by using Voice over IP (VoIP). Each gateway consists of a dedicated computer running custom software that is connected to both a radio and the Internet. This arrangement forms what is known as an IRLP Node.
It is a protocol, implemented in a computer program, used for weak-signal radio communication between amateur radio operators. The protocol was designed, and a program written initially, by Joe Taylor, K1JT. The software code is now open source and is developed by a small team.
From 29.000 MHz to 29.700, The FM sub-band is usually channelized into repeater and simplex frequencies. The channels are commonly grouped into repeater inputs, simplex, and repeater output frequencies. Repeater input frequencies: 29.510, 29.520, 29.530, 29.540, 29.550, 29.560, 29.570, 29.580 and 29.590 MHz.