Search results
Results from the WOW.Com Content Network
PM is most usually (but not always) expressed as mg/m 3 of air or other gas at a specified temperature and pressure. For gases, volume percent = mole percent; 1 volume percent = 10,000 ppmv (i.e., parts per million by volume) with a million being defined as 10 6.
For example, such a regulation might limit the concentration of NOx to 55 ppmv in a dry combustion exhaust gas corrected to 3 volume percent O 2. As another example, a regulation might limit the concentration of particulate matter to 0.1 grain per standard cubic foot (i.e., scf) of dry exhaust gas corrected to 12 volume percent CO 2.
It is the number of Nitrogens x 56.1 (Mwt of KOH) x 1000 (convert to milligrams) divided by molecular mass of the amine functional compound. So using Tetraethylenepentamine (TEPA) as an example: Mwt = 189, number of nitrogen atoms = 5 So 5 x 1000 x 56.1/189 = 1484. So the Amine Value of TEPA = 1484
Mass fraction can also be expressed, with a denominator of 100, as percentage by mass (in commercial contexts often called percentage by weight, abbreviated wt.% or % w/w; see mass versus weight). It is one way of expressing the composition of a mixture in a dimensionless size ; mole fraction (percentage by moles , mol%) and volume fraction ...
When expressed in percent, it is known as the mole percent or molar percentage (unit symbol %, sometimes "mol%", equivalent to cmol/mol for 10-2). The mole fraction is called amount fraction by the International Union of Pure and Applied Chemistry (IUPAC) [ 1 ] and amount-of-substance fraction by the U.S. National Institute of Standards and ...
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
The conversion between hydroxyl value and other hydroxyl content measurements is obtained by multiplying the hydroxyl value by the factor 17/560. [2] The chemical substance may be a fat, oil, natural or synthetic ester, or other polyol. [3] ASTM D 1957 [4] and ASTM E222-10 [5] describe several versions of this method of determining hydroxyl value.
In chemistry, the mass concentration ρ i (or γ i) is defined as the mass of a constituent m i divided by the volume of the mixture V. [1]= For a pure chemical the mass concentration equals its density (mass divided by volume); thus the mass concentration of a component in a mixture can be called the density of a component in a mixture.