enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. GU24 lamp fitting - Wikipedia

   en.wikipedia.org/wiki/GU24_lamp_fitting

   Compact fluorescent lamp with GU24 cap. A GU24 lamp fitting is a bi-pin connector for compact fluorescent lamps (CFL) or LED lamps that uses a bayonet mount–like twist-lock bi-pin connector instead of the Edison screw fitting used on many CFLs, LED lamps and incandescent light bulbs.

3. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

4. Lightbulb socket - Wikipedia

   en.wikipedia.org/wiki/Lightbulb_socket

   GY6.35 & GZ6.35 – same as G6.35 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G8 – 8 mm (0.31496 in) pin spacing GU8 – same as G8 and only denotes what lamp mount clip is needed to hold the actual light bulb in place; GY8.6 – 8.6 mm (0.33858 in) pin spacing; G9 – 9 mm (0.35433 in) pin spacing

5. Electrical ballast - Wikipedia

   en.wikipedia.org/wiki/Electrical_ballast

   The ballast in such systems can equally be a resistor. A number of fluorescent lamp fittings used a filament lamp as the ballast in the late 1950s through to the 1960s. Special lamps were manufactured that were rated at 170 volts and 120 watts. The lamp had a thermal starter built into the 4 pin base.

6. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

7. Multifaceted reflector - Wikipedia

   en.wikipedia.org/wiki/Multifaceted_reflector

   These lamps use a bi-pin connector for power: 12-volt MR11 bulbs usually use a GU4 base, and 12-volt MR16 bulbs usually use a GU5.3 base. The common 12-volt MR16 lamps, therefore, require a ferromagnetic or electronic transformer —sometimes misnamed as a ballast —to convert the 120- or 230-volt mains voltage to the extra-low voltage ...