Search results
Results from the WOW.Com Content Network
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
long code "foot" outputs foot (and never feet) Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 ft (0.30 m) ftin (feet and inches) ft m (foot m) inch: in in Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 in (25 mm) in cm; in mm; Other: nautical mile: nmi nmi the international standard nautical mile
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
The American pica of 0.16604 inches (4.217 mm). It was established by the United States Type Founders' Association in 1886. [1] [2] In TeX one pica is 400 ⁄ 2,409 of an inch. The contemporary computer PostScript pica is exactly 1 ⁄ 6 of an inch or 1 ⁄ 72 of a foot, i.e. 4.2 3 mm or 0.1 6 in.
Traditional Burmese units of measurement are used in Burma, with partial transition to the metric system. U.S. units are used in limited contexts in Canada due to the large volume of trade with the U.S. There is also considerable use of imperial weights and measures, despite de jure Canadian conversion to metric.
Many US tapes also have special markings every 16 inches (406 mm), which is a US standard interval for studs in construction: three spaces of 16 inches make exactly 4 feet (1,219 mm) which is the US commercial width of a sheet of plywood, gyproc or particle board. A dual scale inch/centimeter tape measure.
The U.S. government passed the Metric Conversion Act of 1975, which made the metric system "the preferred system of weights and measures for U.S. trade and commerce". The legislation states that the federal government has a responsibility to assist industry as it voluntarily converts to the metric system, i.e., metrification. This is most ...
Under the Harappan linear measures, Indus cities during the Bronze Age used a foot of 13.2 inches (335 mm) and a cubit of 20.8 inches (528 mm). [11] The Egyptian equivalent of the foot—a measure of four palms or 16 digits—was known as the djeser and has been reconstructed as about 30 cm (11.8 in).