Search results
Results from the WOW.Com Content Network
If the correction factor is greater than one, the reaction displays an asymmetric amplification, also known as a positive non-linear effect. Under the ML 2 model, a (+)-NLE infers a less reactive heterochiral catalyst. In this case, the equilibrium constant K also increases as the correction factor increases.
When determining the stability constants for ternary complexes, M p A q B r it is common practice the fix the values for the corresponding binary complexes M p′ A q′ and M p′′ B q′′, at values which have been determined in separate experiments. Use of such constraints reduces the number of parameters to be determined, but may result ...
In supramolecular chemistry, [1] host–guest chemistry describes complexes that are composed of two or more molecules or ions that are held together in unique structural relationships by forces other than those of full covalent bonds. Host–guest chemistry encompasses the idea of molecular recognition and interactions through non-covalent ...
The polar sensitivity factor ρ* can be obtained by plotting the ratio of the measured reaction rates (k s) compared to the reference reaction versus the σ* values for the substituents. This plot will give a straight line with a slope equal to ρ*. Similar to the Hammett ρ value:
Matrix isolation is an experimental technique used in chemistry and physics. It generally involves a material being trapped within an unreactive matrix. A host matrix is a continuous solid phase in which guest particles (atoms, molecules, ions, etc.) are embedded. The guest is said to be isolated within the host matrix.
The Amott test is one of the most widely used empirical wettability measurements for reservoir cores in petroleum engineering.The method combines two spontaneous imbibition measurements and two forced displacement measurements.
Some empirical relationships are merely approximations, often equivalent to the first few terms of the Taylor series of an analytical solution describing a phenomenon. [citation needed] Other relationships only hold under certain specific conditions, reducing them to special cases of more general relationship. [2]
The response factor can be expressed on a molar, volume or mass [1] basis. Where the true amount of sample and standard are equal: = where A is the signal (e.g. peak area) and the subscript i indicates the sample and the subscript st indicates the standard. [2]