Search results
Results from the WOW.Com Content Network
IPv4 network standards reserve the entire address block 127.0.0.0 / 8 (more than 16 million addresses) for loopback purposes. [2] That means any packet sent to any of those addresses is looped back. The address 127.0.0.1 is the standard address for IPv4 loopback traffic; the rest are not supported by all operating systems. However, they can be ...
127.0.0.0/8 127.0.0.0–127.255.255.255 16 777 216: Host Used for loopback addresses to the local host [1] 169.254.0.0/16 169.254.0.0–169.254.255.255 65 536: Subnet Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172 ...
In both Windows and Linux, when selecting which of a host's IP address to use as a source IP, a program may specify INADDR_ANY (0.0.0.0). [3] [4] In Linux a program may specify 0.0.0.0 as the remote address to connect to the current host (AKA localhost). [2]
The Address Resolution Protocol (ARP) performs this IP-address-to-hardware-address translation for IPv4. In addition, the reverse correlation is often necessary. For example, unless an address is preconfigured by an administrator, when an IP host is booted or connected to a network it needs to determine its IP address.
Any IP datagram with a source or destination address set to a loopback address must not appear outside of a computing system, or be routed by any routing device. Packets received on an interface with a loopback destination address must be dropped. Such packets are sometimes referred to as Martian packets. [1]
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
Local Address – The IP address of the local computer and the port number being used. The name of the local computer that corresponds to the IP address and the name of the port is shown unless the -n parameter is specified. An asterisk (*) is shown for the host if the server is listening on all interfaces.
Each 1-bit denotes a bit of the address range which must remain identical to the given IP address. The IP address in CIDR notation is always represented according to the standards for IPv4 or IPv6. The address may denote a specific interface address (including a host identifier, such as 10.0.0.1 / 8), or it may be the beginning address of an ...