Search results
Results from the WOW.Com Content Network
Definition of the part via a 3D CAD model rather than via a 2D engineering drawing. Drawings may be printed (plotted) from the model for reference use, but the model remains the governing legal instrument. MBP: measurement between pins: threads, splines, gears (internal, female) (synonymous with MBW) (see also MOP, MOW) MBW: measurement between ...
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
When part definition is defined mathematically via a solid model, the assertion that one cannot interrogate the model—the direct analog of "scaling the drawing"—becomes ridiculous; because when part definition is defined this way, it is not possible for a drawing or model to be "not to scale". A 2D pencil drawing can be inaccurately ...
ISO 4172:1991 Technical drawings — Construction drawings — Drawings for the assembly of prefabricated structures; ISO 5261:1995 Technical drawings — Simplified representation of bars and profile sections; ISO 5455:1979 Technical drawings — Scales; ISO 5456 Technical drawings — Projection methods
Model based definition; Construction Project Information Committee; Uniclass; ISO Standards Handbook – Technical drawings, a broad collection of all basic ISO drawing standards Vol.1 Technical drawings in general, ISBN 92-67-10370-9; Vol.2 Mechanical engineering drawings, construction drawings, drawing equipment, ISBN 92-67-10371-7
The drawing was made 130 years after the bridge was built. A linear scale, also called a bar scale, scale bar, graphic scale, or graphical scale, is a means of visually showing the scale of a map, nautical chart, engineering drawing, or architectural drawing. A scale bar is common element of map layouts.
Various scales and the protractor are used to measure the lengths of lines and angles, allowing accurate scale drawing to be carried out. The compass is used to draw arcs and circles. A drawing board was used to hold the drawing media in place; later boards included drafting machines that sped the layout of straight lines and angles.
On engineering drawings, the projection is denoted by an international symbol representing a truncated cone in either first-angle or third-angle projection, as shown by the diagram on the right. The 3D interpretation is a solid truncated cone, with the small end pointing toward the viewer.