Search results
Results from the WOW.Com Content Network
In manufacturing or mechanical engineering a groove is a long and narrow indentation built into a material, generally for the purpose of allowing another material or part to move within the groove and be guided by it. Examples include:
Kionix supplies MEMS devices including tri-axis accelerometers and gyroscopes along with the mixed-signal-interface integrated circuits that provide algorithm processing of sensor data. Its products and technologies include: Accelerometers with one, two, or three axes; low-g or mid-g ranges; Angular rate sensors about the x, y, or z axis
This process removes the material by rotating the facing tool in the counterclockwise direction as the table feeds the work piece across the cutter. Face milling can be achieved with an end mill, but is often done with a face mill, shell mill or a fly cutter. Face milling can be done in both manual machining and CNC machining. To obtain a ...
Turning is a machining process in which a cutting tool, typically a non-rotary tool bit, describes a helix toolpath by moving more or less linearly while the workpiece rotates. Usually the term "turning" is reserved for the generation of external surfaces by this cutting action, whereas this same essential cutting action when applied to ...
A motion detector attached to an outdoor, automatic light. A motion detector is an electrical device that utilizes a sensor to detect nearby motion (motion detection).Such a device is often integrated as a component of a system that automatically performs a task or alerts a user of motion in an area.
Kinect is a discontinued line of motion sensing input devices produced by Microsoft and first released in 2010. The devices generally contain RGB cameras, and infrared projectors and detectors that map depth through either structured light or time of flight calculations, which can in turn be used to perform real-time gesture recognition and body skeletal detection, among other capabilities.
As a blacksmithing tool, a fuller is a type of swage, a tool with a cylindrical or beveled face used to imprint grooves into metal. Fullers are typically three to six inches long. If a groove is to be applied to both sides of the steel, two fullers may be used at the same time, sandwiching the workpiece in the middle.
The removal tool engages with the front portion of the contact and pushes it through to the back of the connector. Rear release contacts are released and removed from the rear (wire side) of the connector. The removal tool releases the contacts from the rear and pulls the contact out of the retainer.