Search results
Results from the WOW.Com Content Network
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
Conductivity or specific conductance of an electrolyte solution is a measure of its ability to conduct electricity. The SI unit of conductivity is siemens per meter (S/m). Conductivity measurements are used routinely in many industrial and environmental applications as a fast, inexpensive and reliable way of measuring the ionic content in a ...
The molar conductivity of an electrolyte solution is defined as its conductivity divided by its molar concentration. [1][2] where: κ is the measured conductivity (formerly known as specific conductance), [3] c is the molar concentration of the electrolyte. The SI unit of molar conductivity is siemens metres squared per mole (S m 2 mol −1). [2]
Wind speed conversion factors. Meteorological data includes wind speeds which may be expressed as statute miles per hour, knots, or meters per second. Here are the conversion factors for those various expressions of wind speed: 1 m/s = 2.237 statute mile/h = 1.944 knots. 1 knot = 1.151 statute mile/h = 0.514 m/s.
Correcting concentrations for altitude. Air pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude. The concentration decrease is directly proportional to the pressure decrease with increasing altitude.
Allen Hazen derived an empirical formula for approximating hydraulic conductivity from grain-size analyses: = where Hazen's empirical coefficient, which takes a value between 0.0 and 1.5 (depending on literature), with an average value of 1.0. A.F. Salarashayeri & M. Siosemarde indicate C is usually between 1.0 and 1.5, with D in mm and K in cm/s.
Those same wavelengths, however, are the ones where emission is also strongest. In an extreme case, roughly 90% of 667.5 cm −1 photons are absorbed within 1 meter by 400 ppm of CO 2 at surface density, [23] but they are replaced by emission of an equal number of 667.5 cm −1 photons. The radiation field thereby maintains the blackbody ...
The SI unit of electrical resistivity is the ohm - metre (Ω⋅m). [1][2][3] For example, if a 1 m3 solid cube of material has sheet contacts on two opposite faces, and the resistance between these contacts is 1 Ω, then the resistivity of the material is 1 Ω⋅m. Electrical conductivity (or specific conductance) is the reciprocal of ...