Search results
Results from the WOW.Com Content Network
Aileron. An aircraft 'rolling', or 'banking', with its ailerons. An aileron and roll trim tab of a light aircraft. An aileron (French for "little wing" or "fin") is a hinged flight control surface usually forming part of the trailing edge of each wing of a fixed-wing aircraft. [1] Ailerons are used in pairs to control the aircraft in roll (or ...
Aileron surface. Ailerons are mounted on the trailing edge of each wing near the wingtips and move in opposite directions. When the pilot moves the aileron control to the left, or turns the wheel counter-clockwise, the left aileron goes up and the right aileron goes down. A raised aileron reduces lift on that wing and a lowered one increases ...
Flight with disabled controls. Throughout a normal flight, a pilot controls an aircraft through the use of flight controls including maintaining straight and level flight, as well as turns, climbing, and descending. Some controls, such as a "yoke" or "stick" move and adjust the control surfaces which affects the aircraft's attitude in the three ...
Adverse yaw. Adverse yaw is the natural and undesirable tendency for an aircraft to yaw in the opposite direction of a roll. It is caused by the difference in lift and drag of each wing. The effect can be greatly minimized with ailerons deliberately designed to create drag when deflected upward and/or mechanisms which automatically apply some ...
However it has ailerons only on its bottom wing, which makes its rate of roll relatively slow for a biplane; and, as stated previously, the ailerons on a Tiger Moth normally operate with a heavy degree of designed-in differential operation (mostly deflecting up, hardly at all downwards) to avoid adverse yaw problems in normal flight. Most ...
The Cessna 152 is equipped with differential ailerons that move through 20 degrees upwards and 15 degrees downwards. It has single-slotted fowler flaps which are electrically operated and deploy to a maximum of 30 degrees. The rudder can move 23 degrees to either side and is fitted with a ground-adjustable trim tab.
A pilot can induce a flat spin once the spin is established by applying full opposite aileron to the direction of rotation—hence, the requirement to neutralize ailerons in the normal spin recovery technique. The aileron application creates a differential induced drag that raises the nose toward a level pitch attitude.
The Kitfox Model 4 was a new design introduced in 1991. It incorporated a laminar flow airfoil, new flaperon design, metal flaperon attach brackets and a new 2:1 differential aileron control system. The gross weight of the Kitfox Model 4-1050 was the same as the Model 3, 1,050 lb (476 kg).