enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   American cabinet saws are normally designed to accept a 13 ⁄ 16-inch-wide (21 mm) stacked dado blade in addition to a standard saw blade. The most common size of blade is 10 inches (250 mm) in diameter with a blade arbor diameter of 5 ⁄ 8 inch (16 mm), but 12 or 14 inches (300 or 360 mm) in diameter with a blade arbor diameter of 1 inch (25 ...

3. Hacksaw - Wikipedia

   en.wikipedia.org/wiki/Hacksaw

   The most common blade is the 12 inch or 300 mm length. Hacksaw blades have a hole at each end for mounting them in the saw frame and the 12 inch / 300 mm dimension refers to the center to center distance between these mounting holes. [3] The kerf produced by the blades is somewhat wider than the blade thickness due to the set of the teeth.

4. Riving knife - Wikipedia

   en.wikipedia.org/wiki/Riving_knife

   Riving knife. A riving knife to the left of the blade on table saw. A riving knife is a safety device installed on a table saw, circular saw, or radial arm saw used for woodworking. Attached to the saw's arbor, it is fixed relative to the blade and moves with it as blade depth is adjusted. [1]

5. Tested And Reviewed: Find Out Which Editor-Approved ... - AOL

   www.aol.com/tested-reviewed-editor-approved...

   For premium support please call: 800-290-4726 more ways to reach us

6. Thickness planer - Wikipedia

   en.wikipedia.org/wiki/Thickness_planer

   Function. A thickness planer is a woodworking machine to trim boards to a consistent thickness throughout their length and flat on both surfaces. It is different from a surface planer, or jointer, where the cutter head is set into the bed surface. A surface planer has slight advantages for producing the first flat surface and may be able to do ...

7. Fence (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Fence_(woodworking)

   The most common fence on a table saw is a rip fence, and is provided as standard with any new table saw. The rip fence is parallel to the saw blade and can be adjusted to different distances from the blade to set the size of the final cut. The fence remains static, while the workpiece is guided along the fence. [5]