enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Methane (data page) - Wikipedia

    en.wikipedia.org/wiki/Methane_(data_page)

    Table data obtained from CRC Handbook of Chemistry and Physics 44th ed. Annotation "(s)" indicates equilibrium temperature of vapor over solid. Otherwise temperature is equilibrium of vapor over liquid. Note that these are all negative temperature values. Methane vapor pressure vs. temperature.

  3. Vapor pressure - Wikipedia

    en.wikipedia.org/wiki/Vapor_pressure

    Vapor pressure [a] or equilibrium vapor pressure is the pressure exerted by a vapor in thermodynamic equilibrium with its condensed phases (solid or liquid) at a given temperature in a closed system. The equilibrium vapor pressure is an indication of a liquid's thermodynamic tendency to evaporate.

  4. Critical point (thermodynamics) - Wikipedia

    en.wikipedia.org/wiki/Critical_point...

    The commonly known phases solid, liquid and vapor are separated by phase boundaries, i.e. pressure–temperature combinations where two phases can coexist. At the triple point, all three phases can coexist. However, the liquid–vapor boundary terminates in an endpoint at some critical temperature T c and critical pressure p c. This is the ...

  5. Kelvin equation - Wikipedia

    en.wikipedia.org/wiki/Kelvin_equation

    The vapour pressure above the curved interface is then higher than that for the planar interface. This picture provides a simple conceptual basis for the Kelvin equation. The change in vapor pressure can be attributed to changes in the Laplace pressure. When the Laplace pressure rises in a droplet, the droplet tends to evaporate more easily.

  6. Antoine equation - Wikipedia

    en.wikipedia.org/wiki/Antoine_equation

    (760 mmHg = 101.325 kPa = 1.000 atm = normal pressure) This example shows a severe problem caused by using two different sets of coefficients. The described vapor pressure is not continuous—at the normal boiling point the two sets give different results. This causes severe problems for computational techniques which rely on a continuous vapor ...

  7. Joule–Thomson effect - Wikipedia

    en.wikipedia.org/wiki/Joule–Thomson_effect

    In thermodynamics, the Joule–Thomson effect (also known as the Joule–Kelvin effect or Kelvin–Joule effect) describes the temperature change of a real gas or liquid (as differentiated from an ideal gas) when it is expanding; typically caused by the pressure loss from flow through a valve or porous plug while keeping it insulated so that no heat is exchanged with the environment.

  8. Vapor–liquid equilibrium - Wikipedia

    en.wikipedia.org/wiki/Vapor–liquid_equilibrium

    The concentration of a vapor in contact with its liquid, especially at equilibrium, is often expressed in terms of vapor pressure, which will be a partial pressure (a part of the total gas pressure) if any other gas(es) are present with the vapor. The equilibrium vapor pressure of a liquid is in general strongly dependent on temperature. At ...

  9. Fugacity - Wikipedia

    en.wikipedia.org/wiki/Fugacity

    The fugacity of a condensed phase (liquid or solid) is defined the same way as for a gas: = ⁡ and = It is difficult to measure fugacity in a condensed phase directly; but if the condensed phase is saturated (in equilibrium with the vapor phase), the chemical potentials of the two phases are equal (μ c = μ g).