enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Thunderbolt (interface) - Wikipedia

   en.wikipedia.org/wiki/Thunderbolt_(interface)

   Thunderbolt 3, 4, or 5 ports USB-C Thunderbolt 3, 4, or 5 connector. Thunderbolt 3 is a hardware interface developed by Intel. [75] It shares USB-C connectors with USB, supports USB 3.1 Gen 2, [76] [77] [78] and can require special "active" cables for maximum performance for cable lengths over 0.5 meters (1.5 feet). Compared to Thunderbolt 2 ...

3. USB4 - Wikipedia

   en.wikipedia.org/wiki/USB4

   The Type-C specification does not name specific DP speeds that it considers supported for passive cables where support is optional for active cables. The USB-C presentation on DP Alt mode [47] calls out passive full-featured USB-C cables for their DisplayPort support and headroom for future DP speed increases. HBR3 was the highest available DP ...

4. USB-C - Wikipedia

   en.wikipedia.org/wiki/USB-C

   Whereas earlier USB cables had a host end A and a peripheral device end B, a USB-C cable connects either way; and for interoperation with older equipment, there are cables with a Type-C plug at one end and either a Type-A (host) or a Type-B (peripheral device) plug at the other. The designation "C" refers only to the connector's physical ...

5. DisplayPort - Wikipedia

   en.wikipedia.org/wiki/DisplayPort

   Formats which would normally be beyond the limits of DisplayPort 1.4, such as 4K (3840 × 2160) at 144 Hz 8 bpc RGB/Y′C B C R 4:4:4 (31.4 Gbit/s data rate when uncompressed), can only be implemented by using DSC. This would reduce the physical bandwidth requirements by 2–3×, placing it well within the capabilities of an HBR2-rated cable.

6. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   The USB-IF used WiGig Serial Extension v1.2 specification as its initial foundation for the MA-USB specification and is compliant with SuperSpeed USB (3.0 and 3.1) and Hi-Speed USB (USB 2.0). Devices that use MA-USB will be branded as "Powered by MA-USB", provided the product qualifies its certification program.

7. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...