Search results
Results from the WOW.Com Content Network
When sensorineural hearing loss (damage to the cochlea or in the brain) is present, the perception of loudness is altered. Sounds at low levels (often perceived by those without hearing loss as relatively quiet) are no longer audible to the hearing impaired, but sounds at high levels often are perceived as having the same loudness as they would for an unimpaired listener.
24-bit and 32-bit audio does not require dithering, as the noise level of the digital converter is always louder than the required level of any dither that might be applied. 24-bit audio could theoretically encode 144 dB of dynamic range, and 32-bit audio can achieve 192 dB, but this is almost impossible to achieve in the real world, as even ...
Signal flow is the path an audio signal will take from source to the speaker or recording device. Signal flow may be short and simple as in a home audio system or long and convoluted in a recording studio and larger sound reinforcement system as the signal may pass through many sections of a large mixing console, external audio equipment, and even different rooms.
The decibel (symbol: dB) is a relative unit of measurement equal to one tenth of a bel (B). It expresses the ratio of two values of a power or root-power quantity on a logarithmic scale. Two signals whose levels differ by one decibel have a power ratio of 10 1/10 (approximately 1.26) or root-power ratio of 10 1/20 (approximately 1.12). [1] [2]
Audiogram. An audiogram is a graph that shows the audible threshold for standardized frequencies as measured by an audiometer.The Y axis represents intensity measured in decibels (dB) and the X axis represents frequency measured in hertz (Hz). [1]
Ampex tape recorders in the 1950s achieved 60 dB in practical usage, [26] In the 1960s, improvements in tape formulation processes resulted in 7 dB greater range, [28]: 158 and Ray Dolby developed the Dolby A-Type noise reduction system that increased low- and mid-frequency dynamic range on magnetic tape by 10 dB, and high-frequency by 15 dB ...
A graph of the A-, B-, C- and D-weightings across the frequency range 10 Hz – 20 kHz Video illustrating A-weighting by analyzing a sine sweep (contains audio). A-weighting is a form of frequency weighting and the most commonly used of a family of curves defined in the International standard IEC 61672:2003 and various national standards relating to the measurement of sound pressure level. [1]
While describing sound in terms of sound pressure, a logarithmic conversion is usually applied and the sound pressure level is stated instead, in decibels (dB), with 0 dB SPL equal to 20 micropascals. A microphone is distinguishable by the voltage value produced when a known, constant root mean square sound pressure is applied. This is known as ...