Search results
Results from the WOW.Com Content Network
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
In the US it is commonly called a brake booster. A vacuum servo, also known as a power booster or power brake unit, uses a vacuum, usually supplied by the engine, to multiply the driver's pedal effort and apply that effort to the master cylinder .
Transmission overhauled with a refurbished clutch plate and new clutch cover, new clutch slave cylinder and clutch release bearing, missing clutch slave cylinder return spring reinstalled, new custom-made hydraulic pipe installed. Seized brakes refurbished by cleaning the brake discs and installing new brake pads. Clutch and brake fluids replaced.
If the transmission control unit senses a critical fault during driving, it will activate an emergency operating mode: Upon hydraulic failures, it will stop shifting gears and permanently retain the currently selected gear; if the failure can be pinpointed to one of the internal hydraulic control valves, the transmission will continue shifting but stop using the affected gear(s).
In a manual transmission vehicle, stop-start is activated by stopping the car, shifting the gear to neutral, and releasing the clutch. The engine will not stop if the car is moving, even if the aforementioned steps are followed (this is not true for all cars). The engine restarts when the clutch is pressed prior to selecting a gear to move the car.
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
The transmission brake is the yellow drum, to the right rear of the transfer box. A transmission brake or driveline parking brake is an inboard vehicle brake that is applied to the drivetrain rather than to the wheels. Historically, some early cars used transmission brakes as the normal driving brake and often had wheel brakes on only one axle ...
A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as ...