Search results
Results from the WOW.Com Content Network
In aircraft, a centrifugal switch is used to control the starting and ignition circuits, the governed speed indication circuit and the overspeed protection circuit of the auxiliary power unit. This switch is mounted inside a rotating body. This can be set to activate or deactivate a circuit as the rpm of device increases or decreases ...
The company began as a division of the Coleman Company in 1958 and was acquired by Evcon in 1990, which in turn was acquired by Johnson Controls in 1996. [70] [71] [72] Of the twelve largest American furnace brand names represented at Gas Furnace Guide, the Coleman brand received an average ranking of 3.7 out of 5 stars. [73]
A thermal expansion valve is a key element to a heat pump; this is the cycle that makes air conditioning, or air cooling, possible.A basic refrigeration cycle consists of four major elements: a compressor, a condenser, a metering device and an evaporator.
If the switch is always open, the start capacitor is not part of the circuit, so the motor does not start. If the switch is always closed, the start capacitor is always in the circuit, so the motor windings will likely burn out. If a motor does not start, the capacitor is far more likely the problem than the switch. [citation needed]
The G.I. pocket stove is 8 + 1 ⁄ 2 inches (220 mm) high and 4 + 1 ⁄ 2 inches (110 mm) in diameter, and weighs about 3 pounds (1.4 kg). It was designed to burn either leaded or unleaded automobile gasoline (sometimes referred to as "white gasoline" or pure gasoline, without lead or additives).
A centrifugal clutch shown in a patent application, 1898. Centrifugal clutches were used in railway locomotives before 1858, [1] and referred to (in relation to electric motors) in a patent of 1899. [2] A patent was issued in the United States for an automotive centrifugal clutch (on an electric vehicle) in 1898. [3]
The usual compression, cooling and expansion seen in any refrigeration cycle is accomplished in the ACM by a centrifugal compressor, two air-to-air heat exchangers and an expansion turbine. Bleed air from the engines, an auxiliary power unit, or a ground source, which can be in excess of 150 °C and at a pressure of perhaps 32 psi (220 kPa ...
A sail switch, vane switch or flow switch is a mechanical switch that is actuated on or off in response to the flow or non-flow of a fluid such as air or water. [1] A sail switch typically operates through the use of a paddle or a diaphragm which gets displaced due to the force of fluid or air moving past it.