Search results
Results from the WOW.Com Content Network
LM336 2.5 V or 5 V Zener reference diode with temperature coefficient trimmer [53] LM368 Yes 2.5 V precision voltage reference [54] LM169 LM369 LM199 Yes 2.5 V temperature compensated precision voltage reference [55] LM185 LM285 LM385 Fixed (1.2 V, 2.5 V) or adjustable micropower voltage reference [56] [57] LM129 LM329 LM129
This is an accepted version of this page This is the latest accepted revision, reviewed on 2 December 2024. Restoring the software of an electronic device to its original state For the Tilian Pearson album, see Factory Reset (album). A factory reset, also known as hard reset or master reset, is a software restore of an electronic device to its original system state by erasing all data ...
For example, in the x86 architecture, asserting the RESET line halts the CPU; this is done after the system is switched on and before the power supply has asserted "power good" to indicate that it is ready to supply stable voltages at sufficient power levels. [2] Reset places less stress on the hardware than power cycling, as the power is not ...
Provided the RCA clean is performed with high-purity chemicals and clean glassware, it results in a very clean wafer surface while the wafer is still submersed in water. The rinsing and drying steps must be performed correctly (e.g., with flowing water) since the surface can be easily recontaminated by organics and particulates floating on the ...
To obtain better performance and lower costs, semiconductor manufacturers reduce the device geometries of integrated circuits. With each reduction the associated operating voltage must also be reduced in order to maintain the same basic operational characteristics of the transistors.
Resettable fuses - PolySwitch devices. A resettable fuse or polymeric positive temperature coefficient device (PPTC) is a passive electronic component used to protect against overcurrent faults in electronic circuits.
[2] For an NPN open emitter output, the collector is connected to the positive voltage rail, so the emitter outputs a high voltage when the transistor is on and is hi-Z when off. For a PNP open emitter output, the collector is connected to the low voltage supply, so the emitter outputs a low voltage when the transistor is on and is hi-Z when off.
A 2 indicates the basis of positive electrode phase, and could be C, N, M, V or T for cobalt, nickel, manganese, vanadium and titanium respectively. A 3 is for the shape of the cell; either R for cylinder or P for prism. N 2 is the maximum diameter (in case of cylindrical cells) or thickness (prismatic cells) in mm.