enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Door - Wikipedia

   en.wikipedia.org/wiki/Door

   DIN 18101/1985 defines interior single molded doors to have a common panel height of 1985 mm (normativ height 2010 mm) at panel widths of 610 mm, 735 mm, 860 mm, 985 mm, 1110 mm, plus a larger door panel size of 1110 mm x 2110 mm. [25] The newer DIN 18101/2014 drops the definition of just five standard door sizes in favor of a basic raster ...

3. Frame and panel - Wikipedia

   en.wikipedia.org/wiki/Frame_and_panel

   Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame ...

4. Hollow-core slab - Wikipedia

   en.wikipedia.org/wiki/Hollow-core_slab

   An alternative is to put a strip of rubber underneath the floor slabs. Hollow-core slabs and wall elements without prestressed steel wire can be formed by extruders. The size of these elements will typically range in width from 600 to 2400 mm, in thickness from 150 to 500 mm, and can be delivered in lengths of up to 24 m. [1]

5. Concrete slab - Wikipedia

   en.wikipedia.org/wiki/Concrete_slab

   A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).

6. Waffle slab - Wikipedia

   en.wikipedia.org/wiki/Waffle_slab

   Waffle slabs are preferred for spans greater than 40 feet (12 m), because, for a given mass of concrete, they are much stronger than flat slabs, flat slabs with drop panels, two-way slabs, one-way slabs, and one-way joist slabs. [2] Section of a waffle slab including beam, ribs, and column head

7. Gypsum block - Wikipedia

   en.wikipedia.org/wiki/Gypsum_block

   A gypsum block is made of gypsum plaster and water. The manufacturing process [1] is automated at production plants where raw gypsum (CaSO 4 ·2H 2 O) is ground and dried, then heated to remove three-quarters of the bound water and thus transformed into calcium sulfate hemihydrate (CaSO 4 ·½H 2 O), also known as gypsum plaster, stucco, calcined gypsum or plaster of Paris.