Search results
Results from the WOW.Com Content Network
Software flow control is a method of flow control used in computer data links, especially RS-232 serial. It uses special codes, transmitted in-band, over the primary communications channel. These codes are generally called XOFF and XON (from "transmit off" and "transmit on", respectively). Thus, "software flow control" is sometimes called "XON ...
In computer networking, a flit (flow control unit or flow control digit) is a link-level atomic piece that forms a network packet or stream. [1] The first flit, called the header flit holds information about this packet's route (namely the destination address) and sets up the routing behavior for all subsequent flits associated with the packet.
The basic idea to overclock part of the frame and to oversize the payload dates back to 1999. [2] Developed in 2011 and released in 2012 by Bosch, CAN FD [3] was developed to meet the need to increase the data transfer rate up to 5 times faster and with larger frame/message sizes for use in modern automotive Electronic Control Units.
In computing, TIME is a command in DEC RT-11, [1] DOS, IBM OS/2, [2] Microsoft Windows [3] and a number of other operating systems that is used to display and set the current system time. [4] It is included in command-line interpreters ( shells ) such as COMMAND.COM , cmd.exe , 4DOS , 4OS2 and 4NT .
Stop-and-wait flow control is the simplest form of flow control. In this method the message is broken into multiple frames, and the receiver indicates its readiness to receive a frame of data. The sender waits for a receipt acknowledgement (ACK) after every frame for a specified time (called a time out).
The control action is the switching on/off of the boiler, but the controlled variable should be the building temperature, but is not because this is open-loop control of the boiler, which does not give closed-loop control of the temperature. In closed loop control, the control action from the controller is dependent on the process output.
A motor controller is a device or group of devices that can coordinate in a predetermined manner the performance of an electric motor. [1] A motor controller might include a manual or automatic means for starting and stopping the motor, selecting forward or reverse rotation, selecting and regulating the speed, regulating or limiting the torque, and protecting against overloads and electrical ...
A control loop is the fundamental building block of control systems in general and industrial control systems in particular. It consists of the process sensor, the controller function, and the final control element (FCE) which controls the process necessary to automatically adjust the value of a measured process variable (PV) to equal the value of a desired set-point (SP).