Search results
Results from the WOW.Com Content Network
Site for old PC without sound cards. Programming the PC Speaker, by Mark Feldman for PC-GPE. Programming the PC Speaker, by Phil Inch: part 1, part 2 (includes a very detailed explanation of how to play back PCM audio on the PC speaker, and why it works) Bleeper Music Maker A freeware to use the PC speaker to make music (superseded by BaWaMI)
CGA was widely supported in PC software up until the 1990s. Some of the software that supported the board was: Visi On (an early GUI, used the 640x200 monochrome mode) Windows 3.0 (and earlier versions, supported the 640x200 monochrome mode [39]) OS/2 1.1 (and earlier versions) Graphics Environment Manager (GEM)
When a plug is inserted, the isolated switch inside the jack informs the motherboard, and the codec sends audio to the headphones. A similar isolated switch is used to detect when a microphone has been plugged in. HD Audio can also sense the presence of an audio dongle. A 10 kΩ pull-up resistor is attached to pin 4 (PRESENCE#). When the HDA ...
Close-up of a sound card PCB, showing electrolytic capacitors, SMT capacitors and resistors, and a YAC512 two-channel 16-bit DAC. [1] The integrated circuit on the left is a 3403 single power supply quad operational amplifier. Sound cards use a digital-to-analog converter (DAC), which converts recorded or generated digital signal data into an ...
Previous HDMI versions use three data channels (each operating at up to 6.0 Gbit/s in HDMI 2.0, or up to 3.4 Gbit/s in HDMI 1.4), with an additional channel for the TMDS clock signal, which runs at a fraction of the data channel speed (one tenth the speed, or up to 340 MHz, for signaling rates up to 3.4 Gbit/s; one fortieth the speed, or up to ...
The Sound BlasterAxx Control Panel has got a Mac OS X version other than the Microsoft Windows version. The Sound BlasterAxx SBX 8 is the only speaker that does not have Bluetooth capability. The Sound BlasterAxx SBX 10 and Sound BlasterAxx SBX 20 are Bluetooth capable and can be used for answering phones calls from iOS and Android smart phones.
Three data pairs carry their designated 8-bit RGB component (red, green, or blue) of the video signal for a total of 24 bits per pixel. The fourth pair carries the TMDS clock. The binary data is encoded using 8b/10b encoding. DVI does not use packetization, but rather transmits the pixel data as if it were a rasterized analog video
The SMBus clock is defined from 10 to 100 kHz while I²C can be 0–100 kHz, 0–400 kHz, 0–1 MHz and 0–3.4 MHz, depending on the mode. This means that an I²C bus running at less than 10 kHz will not be SMBus compliant since the SMBus devices may time out. Many SMBus devices will however support lower frequencies.