Ads
related to: turbo 400 transmission slip yoke
Search results
Results from the WOW.Com Content Network
The Turbo-Hydramatic or Turbo Hydra-Matic (THM) series was developed to replace both the original Hydra-Matic models and the Buick Dynaflow. In its original incarnation as the Turbo-Hydramatic 400, it was first used in the 1964 model year in Cadillacs. The Buick version, which followed shortly thereafter, was known as the Super-Turbine 400.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).
The basis of the Turboglide's unique abilities was its five-element torque converter.Most automatic transmissions have a three-element torque converter, consisting of an impeller (an engine-driven pump); a turbine that rotates with the flywheel; a transmission-driven turbine that receives the energy of the oil propelled by the impeller, and a stator that redirects the recirculating oil so that ...
It was the 4-speed electronically commanded evolution of the 3-speed Turbo-Hydramatic 400, first produced in October 1963. 4L80-Es were optioned only in Chevrolet/GMC pickups, vans, and commercial vehicles, and the Hummer H1.
The A998, later renamed 31RH was a medium-duty, narrow or wide-ratio version of the small-frame A904 transmission for use with medium-power V8 engines and the 3.9 L V6 engine. It was equipped with four direct friction plates. This transmission differed from the A904 by having a reinforced case and internals.
Dynaflow (Buick) The Dynaflow was an automatic transmission used in various forms in Buick cars by the General Motors Corporation from 1947 until 1963. The transmission initially used a five-element torque converter, with two impellers and two stators, as well as a planetary gearset that provided two forward speeds plus reverse.
They were all equipped with the TH-400 automatic. All but the M1028A1 and M1031 used the NP-208 chain drive transfer case. The M1028A1 and M1031 units had a slip-yoke rear output version of the NP-205, which was specified mainly for its PTO capacity. The CUCV series had a governed top speed of 55 mph (89 km/h).
Ads
related to: turbo 400 transmission slip yoke