Search results
Results from the WOW.Com Content Network
Similarly engine oil viscosity and cleanliness is a factor. Use of the incorrect oil type, i.e. SAE 10W40 instead of SAE 5W30, or the failure to change the engine oil or oil filter at factory recommended intervals, can also significantly impair system performance. [citation needed] In 2001, GM showcased the 2002 Cadillac Cien concept car, which ...
The engines were also sold for marine and stationary applications. In a 1938 reorganization, Winton Engine Corporation became the GM Cleveland Diesel Engine Division, and GM's Detroit Diesel Engine Division began production of smaller (50–149 cu in (0.8–2.4 L) per cylinder) diesel engines. Locomotive engines were moved under the GM Electro ...
The International Harvester Company (IHC) has been building its own proprietary truck engines since the introduction of their first truck in 1907. International tended to use proprietary diesel engines. In the 1970s, IHC built the DVT 573 V-8 diesel of 240 and 260 hp (179 and 194 kW) but these were not highly regarded and relatively few were sold.
The LT-1 is a Chevrolet small-block engine produced by the Chevrolet division of General Motors between 1970 and 1972. It was available exclusively in the Corvette and Camaro and was produced in relatively small quantities. It is regarded today as one of the greatest of the Chevrolet small-blocks, an engine that has been in production since 1955.
Detroit Diesel was originally the GM Diesel Division then Detroit Diesel Allison Division until 1988. It made diesel engines for truck, generating set and marine use. Electro-Motive Diesel (EMD) was originally the Electro-Motive Division of GM, until 2005. It made diesel engines and locomotives. See also General Motors Diesel Division and GM ...
General Motors (GM) was founded in September of 1908. On June 1, 2009, at 8 a.m. -- almost 101 years later -- it ceased to exist, and control was handed over to turnaround executive Al Koch ...
The engine had MPFI (multi-port fuel injection), which gave slightly more power and better fuel economy, and two valves per cylinder. The engine had a bore and stroke of 4 + 1 ⁄ 4 in × 4 in (108.0 mm × 101.6 mm), producing 290 hp (216 kW) at 4000 rpm and 410 lb⋅ft (556 N⋅m) at 3200 rpm.
The GM L3B engine is a turbocharged four-cylinder gasoline engine designed by General Motors. It is an undersquare aluminum DOHC inline-four displacing 2.7 liters (165 cid) and tuned for strong low-end torque.