Search results
Results from the WOW.Com Content Network
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
USB signals are transmitted using differential signaling on a twisted-pair data cable with 90 Ω ± 15% characteristic impedance. [6] Low speed (LS) and Full speed (FS) modes use a single data pair, labelled D+ and D−, in half-duplex. Transmitted signal levels are 0.0–0.3 V for logical low, and 2.8–3.6 V for logical high level.
The developer forums regulate the development of the USB connector, of other USB hardware, and of USB software; they are not end-user forums. In 2014, the USB-IF announced the availability of USB-C designs. USB-C connectors can transfer data with rates as much as 10 Gbit/s and provides as much as 100 watts of power. [4]
The 24-pin double-sided connector provides four power–ground pairs, two differential pairs for USB 2.0 data (though only one pair is implemented in a USB-C cable), four pairs for SuperSpeed data bus (only two pairs are used in USB 3.1 mode), two "sideband use" pins, V CONN +5 V power for active cables, and a configuration pin for cable ...
USB 2.0 was released in April 2000, adding a higher maximum signaling rate of 480 Mbit/s (maximum theoretical data throughput 53 MByte/s [29]) named High Speed or High Bandwidth, in addition to the USB 1.x Full Speed signaling rate of 12 Mbit/s (maximum theoretical data throughput 1.2 MByte/s).
The Type-C specification does not name specific DP speeds that it considers supported for passive cables where support is optional for active cables. The USB-C presentation on DP Alt mode [47] calls out passive full-featured USB-C cables for their DisplayPort support and headroom for future DP speed increases. HBR3 was the highest available DP ...
Originally developed by the Personal Computer Memory Card International Association (), the ExpressCard standard is maintained by the USB Implementers Forum ().The host device supports PCI Express, USB 2.0 (including Hi-Speed), and USB 3.0 (SuperSpeed) [2] (ExpressCard 2.0 only) connectivity through the ExpressCard slot; cards can be designed to use any of these modes.