Search results
Results from the WOW.Com Content Network
An intermediate switch can, however, be implemented by adding appropriate external wiring to an ordinary (six terminal) DPDT switch, or by using a separate DPDT relay. By connecting one or more 4-way (intermediate) switches in-line, with 3-way switches at either end, the load can be controlled from three or more locations.
The timer may switch equipment on, off, or both, at a preset time or times, after a preset interval, or cyclically. A countdown time switch switches power, usually off, after a preset time. A cyclical timer switches equipment both on and off at preset times over a period, then repeats the cycle; the period is usually 24 hours or 7 days.
The delay box acts as an on-board timer for the transbrake (from transmission brake). A transbrake is a part of a racing automatic transmission used in drag racing, and are not found in manual transmissions. The electronic timer is packaged in a metal enclosure when sold to drag racers, thus the slang term delay box.
A typical kitchen timer. A timer or countdown timer is a type of clock that starts from a specified time duration and stops upon reaching 00:00. An example of a simple timer is an hourglass. Commonly, a timer triggers an alarm when it ends. A timer can be implemented through hardware or software.
DIN rail mounted electronic lighting timer. An electronic timer allow simple push-buttons to be used. One timer is installed controlling the lights and any number of push-buttons, without pneumatic timers and connected in parallel, are used to trigger it. [1] [4] With many push-buttons, the cost savings for equipment may be substantial.
A 3-way lamp, also known as a tri-light, is a lamp that uses a 3-way light bulb to produce three levels of light in a low-medium-high configuration. A 3-way lamp requires a 3-way bulb and socket, and a 3-way switch. In 3-way incandescent light bulbs, each of the filaments operates at full voltage. Lamp bulbs with dual carbon filaments were ...
In modern coordinated signal systems, it is possible for drivers to travel long distances without encountering a red light. This coordination is done easily only on one-way streets with fairly constant levels of traffic. Two-way streets are often arranged to correspond with rush hours to speed the heavier volume direction. Congestion can often ...
A diagram of a countdown timer in the US style. Pedestrian countdown timers are becoming common at urban signal-controlled crossings. Where a pedestrian countdown is shown, it is normally used in conjunction with the flashing hand signal (in the US and Canada) or blackout period (UK), showing the amount of time remaining in seconds until the ...