Search results
Results from the WOW.Com Content Network
In CP/M, attempting to read a floppy disk drive with the door open would hang until a disk was inserted and the disk drive door was closed (very early disk hardware did not send any kind of signal until a disk was spinning, and a timeout to detect the lack of signal required too much code on these tiny systems). Many users of CP/M became ...
Typing recover at the DOS command-line invoked the program file RECOVER.COM or RECOVER.EXE (depending on the DOS version). recover proceeded under the assumption that all directory information included on a disk or disk partition was hopelessly corrupted, but that the FAT and non-directory areas might still contain useful information (though there might be additional bad disk sectors not ...
Some commands are built into the command interpreter; others exist as external commands on disk. Over multiple generations, commands were added for additional functions. In Microsoft Windows, a command prompt window that uses many of the same commands, cmd.exe, can still be used.
The Recovery Console has a simple command-line interpreter (or CLI). Many of the available commands closely resemble the commands that are normally available in cmd.exe, namely attrib, copy, del, and so forth. From the Recovery Console an administrator can: create and remove directories, and copy, erase, display, and rename files
The chkdsk command on Windows XP. CHKDSK can be run from DOS prompt, Windows Explorer, Windows Command Prompt, Windows PowerShell or Recovery Console. [10] On Windows NT operating systems, CHKDSK can also check the disk surface for bad sectors and mark them (in MS-DOS 6.x and Windows 9x, this is a task done by Microsoft ScanDisk).
The installed disks and their associated volumes and/or partitions can be viewed using these commands: list disk list volume list partition The sel command will select them. The command clean will perform a "quick" disk wipe, and clean all zeroes out the entire partition/disk.
This is a list of POSIX (Portable Operating System Interface) commands as specified by IEEE Std 1003.1-2024, which is part of the Single UNIX Specification (SUS). These commands can be found on Unix operating systems and most Unix-like operating systems.
The command is also available in FreeDOS [5] and PTS-DOS. [6] The Windows SUBST command is available in supported versions of the command line interpreter cmd.exe. [7] In Windows NT, SUBST uses DefineDosDevice() to create the disk mappings. The JOIN command is the "opposite" of SUBST, because JOIN will take a drive letter and make it appear as ...