Search results
Results from the WOW.Com Content Network
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
A LM317 commonly requires a heat sink to prevent the operating temperature from rising too high. For large voltage differences, the power lost as heat can ultimately be greater than that provided to the circuit. This is the tradeoff for using linear regulators, which are a simple way to provide a stable voltage with few additional components.
LM317: Adjustable 1.5 A positive voltage regulator (1.25 V-37 V) [62] LM120 LM320 Fixed 1.5 A negative voltage regulator (-5 V, -12 V, -15 V) [63] LM123 LM323 Fixed 3 A, 5-volt positive voltage regulator [64] LM325 Yes Dual ±15-volt voltage regulator [65] LM330 5-volt positive voltage regulator, 0.6 V input-output difference [66] LM333 Yes
An ICD is the umbrella document over the system interfaces; examples of what these interface specifications should describe include: The inputs and outputs of a single system, documented in individual SIRS (Software Interface Requirements Specifications) and HIRS (Hardware Interface Requirements Specifications) documents, would fall under "The Wikipedia Interface Control Document".
A tray of application-specific integrated circuit (ASIC) chips A packet processing ASIC inside an Ethernet switch An application-specific integrated circuit ( ASIC / ˈ eɪ s ɪ k / ) is an integrated circuit (IC) chip customized for a particular use, rather than intended for general-purpose use, such as a chip designed to run in a digital ...
An electronic kit is a package of electrical components used to build an electronic device. Generally, kits are composed of electronic components, a circuit diagram (schematic), assembly instructions, and often a printed circuit board (PCB) or another type of prototyping board. There are two types of kits. Some build a single device or system.
On a circuit diagram, the symbols for components are labelled with a descriptor or reference designator matching that on the list of parts. For example, C1 is the first capacitor, L1 is the first inductor, Q1 is the first transistor, and R1 is the first resistor. Often the value or type designation of the component is given on the diagram ...
Electret microphone capsules This typical electret microphone circuit has a common source configured JFET inside the two-terminal electret capsule. The JFET is externally-powered by the DC voltage V + through a resistor which sets the gain and output impedance.