Search results
Results from the WOW.Com Content Network
A scale of chords may be used to set or read an angle in the absence of a protractor. To draw an angle, compasses describe an arc from origin with a radius taken from the 60 mark. The required angle is copied from the scale by the compasses, and an arc of this radius drawn from the sixty mark so it intersects the first arc.
A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A".
A 1:1 scale construction drawing of a boat and its parts Lines plan A scaled-down version of a full-sized drawing often including the body, plan, profile, and section views Body Plan A view of the boat from both dead ahead and dead astern split in half Plan view A view looking down on the boat from above Profile view A view of the boat from the ...
The issuance of a drawing from the engineering/design activity to the production activity. In other words, the event when a draft becomes a completed, official document. A stamp on the drawing saying "ISSUED" documents that RTP has occurred. RTV: room-temperature vulcanizing; return to vendor: 1. RTV sealants, a way to seal joints. 2.
A drawing which based on the detailed drawing, installation drawing or co-ordination drawing (interface drawing) with the primary purpose of defining that information needed by the tradesmen on site to install the works or concurrently work among various engineering assembly. The main features of typical installation drawings are:
Plans are usually "scale drawings", meaning that the plans are drawn at specific ratio relative to the actual size of the place or object. Various scales may be used for different drawings in a set. For example, a floor plan may be drawn at 1:50 (1:48 or 1 ⁄ 4 ″ = 1′ 0″) whereas a detailed view may be drawn at 1:25 (1:24 or 1 ⁄ 2 ...
A cutaway drawing is a technical illustration, in which part of the surface of a three-dimensional model is removed in order to show some of the model's interior in relation to its exterior. The purpose of a cutaway drawing is to "allow the viewer to have a look into an otherwise solid opaque object.
Various scales and the protractor are used to measure the lengths of lines and angles, allowing accurate scale drawing to be carried out. The compass is used to draw arcs and circles. A drawing board was used to hold the drawing media in place; later boards included drafting machines that sped the layout of straight lines and angles.