enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bi-amping and tri-amping - Wikipedia

   en.wikipedia.org/wiki/Bi-amping_and_tri-amping

   Bi-amping - An active crossover with two amplifiers.. Bi-amping and tri-amping is the practice of using two or three audio amplifiers respectively to amplify different audio frequency ranges, with the amplified signals being routed to different speaker drivers, such as woofers, subwoofers and tweeters.

3. Bi-wiring - Wikipedia

   en.wikipedia.org/wiki/Bi-wiring

   Amplifier and loudspeaker with two elements and crossover networks. Top: normal connection. Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two ...

4. Vehicle audio - Wikipedia

   en.wikipedia.org/wiki/Vehicle_audio

   Some head units have built-in stereo amplifiers. Other car audio systems use a separate stand-alone amplifier. Every amplifier has a rated power level sometimes noted on the head unit with the built-in amplifier, or on the label of a stand-alone unit. Coaxial speakers: These are the most common type of car speakers and are often factory-installed.

5. Speaker wire - Wikipedia

   en.wikipedia.org/wiki/Speaker_wire

   [citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.

6. Bridged and paralleled amplifiers - Wikipedia

   en.wikipedia.org/wiki/Bridged_and_paralleled...

   A bridge-tied load (BTL), also known as bridged transformerless and bridged mono, is an output configuration for audio amplifiers, a form of impedance bridging used mainly in professional audio & car applications. [1] The two channels of a stereo amplifier are fed the same monaural audio signal, with one channel's electrical polarity reversed.

7. Line level - Wikipedia

   en.wikipedia.org/wiki/Line_level

   Line out provides an audio signal output and line in receives a signal input. The line in/out connections on consumer-oriented audio equipment are typically unbalanced, with a 3.5 mm (0.14 inch, but commonly called "eighth inch") 3-conductor TRS minijack connector providing ground, left channel, and right channel, or stereo RCA jacks.