Search results
Results from the WOW.Com Content Network
If you want to set a trunk between two switches when DTP is disabled, you must manually configure trunking using the (switchport mode trunk) command on both sides. The configured switch port mode setting is referred to as the port's trunking administrative mode. The current behavior of a given port after negotiating with the neighboring port is ...
To do this, VTP carries VLAN information to all the switches in a VTP domain. VTP advertisements can be sent over 802.1Q, and ISL trunks. VTP is available on most of the Cisco Catalyst Family products. Using VTP, each Catalyst Family Switch advertises the following on its trunk ports: Management domain; Configuration revision number
Inter-Switch Link (ISL) is a Cisco proprietary protocol used to interconnect switches and maintain VLAN information as traffic travels between switches on trunk links. ISL is provided as an alternative to IEEE 802.1Q. ISL is available only on some Cisco equipment and has been deprecated. [11]
In computer networking, port trunking is the use of multiple concurrent network connections to aggregate the link speed of each participating port and cable, also called link aggregation. Such high-bandwidth link groups may be used to interconnect switches or to connect high-performance servers to a network.
This mode is similar to the XOR mode above and supports the same balancing policies. The link is set up dynamically between two LACP-supporting peers. Adaptive transmit load balancing (balance-tlb) Linux bonding driver mode that does not require any special network-switch support.
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), [1] which allows port channels to be split between two chassis. PAgP is not supported in Cisco Nexus Switches.
The switch forwards all frames received from a private port to the uplink port, regardless of VLAN ID or destination MAC address. Frames received from an uplink port are forwarded in the normal way (i.e. to the port hosting the destination MAC address, or to all ports of the VLAN for broadcast frames or for unknown destination MAC addresses).
EtherChannel between a switch and a server. EtherChannel is a port link aggregation technology or port-channel architecture used primarily on Cisco switches.It allows grouping of several physical Ethernet links to create one logical Ethernet link for the purpose of providing fault-tolerance and high-speed links between switches, routers and servers.