enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Seasonal thermal energy storage - Wikipedia

   en.wikipedia.org/wiki/Seasonal_thermal_energy...

   A ground source heat pump is used in winter to extract the warmth from the Thermal Bank to provide space heating via underfloor heating. A high Coefficient of performance is obtained because the heat pump starts with a warm temperature of 25 °C (77 °F) from the thermal store, instead of a cold temperature of 10 °C (50 °F) from the ground. [17]

3. What should you set your heat to in the winter? Avoid ... - AOL

   www.aol.com/set-heat-winter-avoid-thermostat...

   The Energy Department says that even turning thermostats back 7 to 10 degrees from their normal settings for eight hours a day can save as much as 10% a year on homeowners' heating and cooling ...

4. Seasonal energy efficiency ratio - Wikipedia

   en.wikipedia.org/wiki/Seasonal_energy_efficiency...

   For a heat pump with the minimum 13 SEER cooling efficiency, this is typically below −10 °F (−23 °C). [ 17 ] Lower temperatures may cause a heat pump to operate below the efficiency of a resistance heater, so conventional heat pumps often include heater coils or auxiliary heating from LP or natural gas to prevent low efficiency operation ...

5. Heating seasonal performance factor - Wikipedia

   en.wikipedia.org/wiki/Heating_seasonal...

   The HSPF is related to the non-dimensional Coefficient of Performance (COP) for a heat pump, which measures the ratio of heat delivered to work done by the compressor. The HSPF can be converted to a seasonally-averaged COP assuming a lossless compressor and no heat loss by multiplying by the heat/energy equivalence factor .29307111 watts per BTU.

6. What homeowners need to know before getting a heat pump - AOL

   www.aol.com/news/heating-home-way-could-bag...

   For premium support please call: 800-290-4726 more ways to reach us

7. Ground source heat pump - Wikipedia

   en.wikipedia.org/wiki/Ground_source_heat_pump

   These heat pumps are also preferred for pool heating. Heat pumps typically only heat water to about 55 °C (131 °F) efficiently, whereas boilers typically operate at 65–95 °C (149–203 °F) [citation needed]. The size of radiators designed for the higher temperatures achieved by boilers may be too small for use with heat pumps, requiring ...

8. 26 Grocery Fuel Rewards Programs That Will Cut Your Gas Costs

   www.aol.com/26-grocery-fuel-rewards-programs...

   Filling up at the pump can be painful. ... you can redeem up to 1,000 points for $1 off per gallon in 100-point increments up to 35 gallons. At participating Shell locations, you can redeem 100 ...

9. Coefficient of performance - Wikipedia

   en.wikipedia.org/wiki/Coefficient_of_performance

   The COP usually exceeds 1, especially in heat pumps, because instead of just converting work to heat (which, if 100% efficient, would be a COP of 1), it pumps additional heat from a heat source to where the heat is required. Most air conditioners have a COP of 3.5 to 5. [3]