Search results
Results from the WOW.Com Content Network
In recent years, this drainage concept is more often used in both indoor and outdoor applications, such as fire stations, car washes, landscaping, shower rooms and garages, as well as highly-sanitized environments like food processing plants and breweries. [1] A slot drain is a modified trench drain. "Slot" describes its appearance on the ground.
A trench drain (also known as a channel drain, line drain, slot drain, linear drain, or strip drain) is a specific type of floor drain featuring a trough- or channel-shaped body. It is designed for the rapid evacuation of surface water or for the containment of utility lines or chemical spills.
The interception rate of channel drainage is greater than point drainage and the excavation required is usually much less deep. The surface opening of channel drainage usually comes in the form of gratings (polymer, plastic, steel or iron) or a single slot (slot drain) that run along the ground surface (typically manufactured from steel or iron).
A diagram of a traditional French drain. A French drain [1] (also known by other names including trench drain, blind drain, [1] rubble drain, [1] and rock drain [1]) is a trench filled with gravel or rock, or both, with or without a perforated pipe that redirects surface water and groundwater away from an area.
A percolation trench, also called an infiltration trench, is a type of best management practice (BMP) that is used to manage stormwater runoff, prevent flooding and downstream erosion, and improve water quality in an adjacent river, stream, lake or bay. It is a shallow excavated trench filled with gravel or crushed stone that is designed to ...
Steel corrugated culvert with a drop on the exhaust end, northern Vermont. Culverts can be constructed of a variety of materials including cast-in-place or precast concrete (reinforced or non-reinforced), galvanized steel, aluminum, or plastic (typically high-density polyethylene). Two or more materials may be combined to form composite ...
This was very labour-intensive but could often be done using free materials at hand. Typically they were two to three feet (600mm-900mm) below the surface. Agricultural land drains have to be installed sufficiently deep to avoid plough damage. In 1843 in England short earthenware pipes were first used laid edge to edge. The earliest type ...
A ditch can be used for drainage, to drain water from low-lying areas, alongside roadways or fields, or to channel water from a more distant source for plant irrigation. Ditches are commonly seen around farmland, especially in areas that have required drainage, such as The Fens in eastern England and much of the Netherlands.