enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   An 8P8C modular plug. This is the common crimp-type plug, of the same kind pictured above crimped onto a cable (with molded sleeve). A modular connector is a type of electrical connector for cords and cables of electronic devices and appliances, such as in computer networking, telecommunication equipment, and audio headsets.

3. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   6P4C crimp-on style connector, commonly used for RJ11 and unpowered RJ14 The most widely implemented registered jack in telecommunications is the RJ11. This is a modular connector wired for one telephone line, using the center two contacts of six available positions.

4. Crimp (joining) - Wikipedia

   en.wikipedia.org/wiki/Crimp_(joining)

   The bottom middle cable is missing its crimping collar. A wire and connector in a crimping tool. An electrical crimp is a type of solderless electrical connection which uses physical pressure to join the contacts. Crimp connectors are typically used to terminate stranded wire. [4]

5. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Ring style wire-end crimp connectors The connectors in the top row of the image are known as ring terminals and spade terminals (sometimes called fork or split ring terminals). Electrical contact is made by the flat surface of the ring or spade, while mechanically they are attached by passing a screw or bolt through them.

6. BNC connector - Wikipedia

   en.wikipedia.org/wiki/BNC_connector

   Typically the male connector is fitted to a cable, and the female to a panel on equipment. Cable connectors are often designed to be fitted by crimping [4] using a special power or manual tool. [5] [failed verification] Wire strippers which strip outer jacket, shield braid, and inner dielectric to the correct lengths in one operation are used. [6]

7. Punch down tool - Wikipedia

   en.wikipedia.org/wiki/Punch_down_tool

   To use the punch down tool, a wire is pre-positioned into a slotted post on a punch block, and then the punch down tool is pressed down on top of the wire, over the post. Once the required pressure is reached, an internal spring is triggered, and the blade pushes the wire into the slot, simultaneously cutting the insulation and securing the ...

8. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

9. GG45 - Wikipedia

   en.wikipedia.org/wiki/GG45

   GG45 is a variant of ARJ45 that allows for cables terminated with male 8P8C (AKA RJ45) connectors to be plugged into GG45 jacks. However, GG45 cables cannot plug into 8P8C jacks as a protrusion on the socket is designed to activate a switch on the jack for the alternative contact positions. [2]