Search results
Results from the WOW.Com Content Network
ROM and RAM are essential components of a computer, each serving distinct roles. RAM, or Random Access Memory, is a temporary, volatile storage medium that loses data when the system powers down. In contrast, ROM, being non-volatile, preserves its data even after the computer is switched off. [2]
Software can "partition" a portion of a computer's RAM, allowing it to act as a much faster hard drive that is called a RAM disk. A RAM disk loses the stored data when the computer is shut down, unless memory is arranged to have a standby battery source, or changes to the RAM disk are written out to a nonvolatile disk.
An additional advantage of ROM on some early PC systems (notably including the IBM PCjr) was that ROM was faster than main system RAM. (On modern systems, the case is very much the reverse of this, and BIOS ROM code is usually copied ("shadowed") into RAM so it will run faster.)
The operating system will place actively used data in RAM, which is much faster than hard disks. When the amount of RAM is not sufficient to run all the current programs, it can result in a situation where the computer spends more time moving data from RAM to disk and back than it does accomplishing tasks; this is known as thrashing.
A computer which may be used to provide services to clients. software Any computer program or other kind of information that can be read and/or written by a computer. single in-line memory module (SIMM) A type of memory module containing random-access memory used in computers from the early 1980s to the late 1990s. Contrast DIMM. solid-state drive
The first software RAM drive for microcomputers was invented and written by Jerry Karlin in the UK in 1979/80. The software, known as the Silicon Disk System, was further developed into a commercial product and marketed by JK Systems Research which became Microcosm Research Ltd when the company was joined by Peter Cheesewright of Microcosm Ltd.
It is one type of read-only memory (ROM). PROMs are used in digital electronic devices to store permanent data, usually low level programs such as firmware or microcode. The key difference from a standard ROM is that the data is written into a ROM during manufacture, while with a PROM the data is programmed into them after manufacture. Thus ...
When a system on a chip (SoC) enters suspend to RAM mode, in many cases, the processor is completely off while the RAM is put in self refresh mode. At resume, the boot ROM is executed again and many boot ROMs are able to detect that the SoC was in suspend to RAM and can resume by jumping directly to the kernel which then takes care of powering on again the peripherals which were off and ...