Search results
Results from the WOW.Com Content Network
The desktop computer power supply converts the alternating current (AC) from a wall socket of mains electricity to a low-voltage direct current (DC) to operate the motherboard, processor and peripheral devices. Several direct-current voltages are required, and they must be regulated with some accuracy to provide stable operation of the computer.
A power-on self-test (POST) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on. [ 1 ] POST processes may set the initial state of the device from firmware and detect if any hardware components are non-functional.
HP 2115A computer pictured without its power supply. Led by Magleby, the new division completed the design as the 2116A, which was demonstrated 7–10 November 1966 at the Joint Computer Conference in San Francisco.
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
systemd, a software suite providing system components for Linux operating systems, implements a blue screen of death similar to that of Microsoft Windows using a systemd unit called systemd-bsod since August 2023, which was fully added on December 6, 2023 starting with version 255 of systemd. [38]
A switched-mode power supply will be affected if the brownout voltage is lower than the minimum input voltage of the power supply. As the input voltage falls, the current draw will increase to maintain the same output voltage and current, until such a point that the power supply malfunctions or its under-voltage protection kicks in and disables ...
In contrast, a linear power supply regulates the output voltage by continually dissipating power in the pass transistor. The switched-mode power supply's higher electrical efficiency is an important advantage. Switched-mode power supplies can also be substantially smaller and lighter than a linear supply because the transformer can be much smaller.
Many computer servers offer the option of redundant power supplies, so that in the event of one power supply failing, one or more other power supplies are able to power the load. This is a critical point – each power supply must be able to power the entire server by itself.