Search results
Results from the WOW.Com Content Network
[1] [2] It is usually measured as an equivalent liquid surface elevation, expressed in units of length, at the entrance (or bottom) of a piezometer. In an aquifer, it can be calculated from the depth to water in a piezometric well (a specialized water well), and given information of the piezometer's elevation and screen depth. Hydraulic head ...
Groundwater is water located beneath the earth's surface in pores and fractures of soil and rocks. [6] Hydraulic head (or piezometric head) is a specific measurement of the potential of water above a vertical datum. [7] It is the height of the free surface of water above a given point beneath the surface. [4]
The portion above the water table is the vadose zone. It may be visualized as the "surface" of the subsurface materials that are saturated with groundwater in a given vicinity. [2] In coarse soils, the water table settles at the surface where the water pressure head is equal to the atmospheric pressure (where gauge pressure = 0
However, when the local water table height is within said five meters, the total stress felt five meters below the surface is decreased by the product of the height of the water table in to the five meter area, and the specific weight of water, 9.81 kN/m^3. This parameter is called the effective stress of the soil, basically equal to the ...
In an unconfined aquifer, the water level in the piezometer would not be exactly coincident with the water table, especially when the vertical component of flow velocity is significant. In a confined aquifer under artesian conditions, the water level in the piezometer indicates the pressure in the aquifer, but not necessarily the water table. [34]
For groundwater "potentiometric surface" is a synonym of "piezometric surface" which is an imaginary surface that defines the level to which water in a confined aquifer would rise were it completely pierced with wells. [1] If the potentiometric surface lies above the ground surface, a flowing artesian well results.
One would not want the water table to be too shallow to avoid crop yield depression nor too deep to avoid drought conditions. This is a subject of drainage research. The figure shows that a seasonal average depth of the water table shallower than 70 cm causes a yield depression [5] The figure was made with the SegReg program for segmented ...
For example, if the original fluid was water and we replaced it with mercury at the same pressure, we would expect to see a rather different value for pressure head. In fact the specific weight of water is 9.8 kN/m 3 and the specific weight of mercury is 133 kN/m 3. So, for any particular measurement of pressure head, the height of a column of ...