Search results
Results from the WOW.Com Content Network
For liquid, the dynamic viscosity is usually in the range of 0.001 to 1 Pascal-second, or 1 to 1000 centiPoise. The density is usually on the order of 1000 kg/m^3, i.e. that of water. Consequently, if a liquid has dynamic viscosity of n centiPoise, and its density is not too different from that of water, then its kinematic viscosity is around n ...
For liquids, it corresponds to the informal concept of thickness; for example, syrup has a higher viscosity than water. [2] Viscosity is defined scientifically as a force multiplied by a time divided by an area. Thus its SI units are newton-seconds per square meter, or pascal-seconds. [1] Viscosity quantifies the internal frictional force ...
The poise is often used with the metric prefix centi-because the viscosity of water at 20 °C (standard conditions for temperature and pressure) is almost exactly 1 centipoise. [3] A centipoise is one hundredth of a poise, or one millipascal-second (mPa⋅s) in SI units (1 cP = 10 −3 Pa⋅s = 1 mPa⋅s). [4] The CGS symbol for the centipoise ...
It has dimensions (mass / (length × time)), and the corresponding SI unit is the pascal-second (Pa·s). Like other material properties (e.g. density , shear viscosity , and thermal conductivity ) the value of volume viscosity is specific to each fluid and depends additionally on the fluid state, particularly its temperature and pressure .
μ (some authors use the symbol η) is the dynamic viscosity (Pascal-seconds, kg m −1 s −1); R is the radius of the spherical object (meters); is the flow velocity relative to the object (meters per second). Note the minus sign in the equation, the drag force points in the opposite direction to the relative velocity: drag opposes the motion.
where μ = effective viscosity in centipoise ρ = density in g/cm 3 t = quart funnel time in seconds For example, a mud of funnel time 40 seconds and density 1.1 g/cm 3 has an effective viscosity of about 16.5 cP. For the range of times of typical muds above, the shear rate in the Marsh funnel is about 2000 s −1. [4]
1 reyn = 1 lb f s in −2. It follows that the relation between the reyn and the poise is approximately 1 reyn = 6.89476 × 10 4 P. In SI units, viscosity is expressed in newton-seconds per square meter, or equivalently in pascal-seconds. The conversion factor between the two is approximately 1 reyn = 6890 Pa s.
The values below 0 °C refer to supercooled water. Viscosity [11] 1.7921 ... η – Viscosity in micropascal-seconds (1 cP ... are in pascals. Over liquid water ...