Search results
Results from the WOW.Com Content Network
Alternatively, the ignition-limiting threshold is determined by performing a proper ignition test described in BSI PAS 95:2011 Hypoxic air fire prevention systems specification. [ 4 ] Smoke detectors are installed in protected volumes because, similar to gas suppression systems , hypoxic air does not prevent smoldering and pyrolyzing processes.
When equipment must be placed in a hazardous location, it can be designed to reduce the risk of fire or explosion. Intrinsic safety designs equipment to operate using minimal energy, insufficient to cause ignition. Explosion-proofing designs equipment to contain ignition hazards, prevent entry of hazardous substances, and, contain any fire or ...
Fire safety equipment at a construction site in China Property loss caused by arson. Fire safety is the set of practices intended to reduce destruction caused by fire.Fire safety measures include those that are intended to prevent the ignition of an uncontrolled fire and those that are used to limit the spread and impact of a fire.
Construction site safety is an aspect of construction-related activities concerned with protecting construction site workers and others from death, injury, disease or other health-related risks. Construction is an often hazardous, predominantly land-based activity where site workers may be exposed to various risks, some of which remain ...
The cause was found by a Health and Safety Executive report to be the ignition of gas from a ruptured pipe. Nine people were killed and 37 were injured, 15 seriously. On July 30, 2004, the a natural gas pipeline exploded in Ghislenghien, Belgium. The leak was a result of the damage from a previous construction work.
Once the lower explosive limit (LEL) is reached, any source of ignition will cause an explosion of the vapors. A fuel explosion within the confines of the firebox may damage the pressurized boiler tubes and interior shell, potentially triggering structural failure, steam or water leakage, and/or a secondary boiler shell failure and steam ...
These effects can largely be overcome using electronic ignition systems, where the contact breakers are retrofitted by a magnetic (Hall effect) or optical sensor device. However, because of their simplicity, and since contact breaker points gradually degrade instead of catastrophically failing, they are still used on aircraft engines.
A fault tree diagram. Fault tree analysis (FTA) is a type of failure analysis in which an undesired state of a system is examined. This analysis method is mainly used in safety engineering and reliability engineering to understand how systems can fail, to identify the best ways to reduce risk and to determine (or get a feeling for) event rates of a safety accident or a particular system level ...