Search results
Results from the WOW.Com Content Network
For ALDL connections, pin 9 is the data stream, pins 4 and 5 are ground, and pin 16 is the battery voltage. An OBD 1.5 compatible scan tool is required to read codes generated by OBD 1.5. Additional vehicle-specific diagnostic and control circuits are also available on this connector.
Unfortunately, the definition of which signals were present on each pin varied between vehicle models. There were generally only three pins used for basic ALDL —ground, battery voltage, and a single line for data—, although other pins were often used for additional vehicle-specific diagnostic information and control interfaces.
English: OBD-II type B female connector shape and pinout (The pins inside the connector are female, while the connector itself —the plastic body— is male). Español: Aspecto y posición de los contactos en un conector OBD-II hembra (los contactos son hembra, pero el cuerpo del conector es macho).
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections .
The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.
The role “ground” may be ambiguous in systems that isolate different kinds of grounds (typical isolated grounds are analog signal ground, digital signal ground, AC power ground, DC power ground, and chassis ground). If different kinds of ground paths are in separate paths in a connector, the analysis should treat them as separate signals.
The same style of connector, in single or paired 4-, 6-, or 8-pin configurations, may be used for additional CPU power and graphics card power. Power delivery to these devices has increased in successive generations of PC components, as their higher signal sophistication and speed requirements have raised their electrical demands.