Search results
Results from the WOW.Com Content Network
The ATA/ATAPI sub-command for setting the level of AAM operation is an 8-bit value from 0 to 255. Most modern drives ship with the vendor-defined value of 0x00 in the acoustic management setting. This often translates to the max-performance value of 254 stated in the standard.
The SCSI commands and responses are embedded in "packets" (hence "ATA Packet Interface") for transmission on the ATA cable. This interfaces ATA with any device class for which a SCSI command set has been defined. ATAPI devices are also "speaking ATA" because the ATA physical interface and protocol are still being used to send the packets.
SAT-2 was finalized in 2009. Significant additions in SAT-2 are ATAPI translations, NCQ control, persistent reservations, non-volatile cache translation, and ATA security mode translations. [3] The standard also defines a new data structure returned in the sense data known as the ATA Return Descriptor that contains the ATA taskfile registers.
USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions USB 3.0 host controller (xHCI) provides hardware support for streams
[10] [4] [11] [12] When a newer Serial ATA (SATA) was introduced in 2003, the original ATA was renamed to Parallel ATA, or PATA for short. [ 13 ] Physical ATA interfaces became a standard component in all PCs, initially on host bus adapters, sometimes on a sound card but ultimately as two physical interfaces embedded in a Southbridge chip on a ...
ATATool must be run with administrator privileges. On Windows Vista and later it requires an elevated-privileges command prompt (see User Account Control). The target drive must be connected to a physical disk controller. The software will not work when using a hard drive through an external connection like USB or any external hard drive.
The USB mass storage device class (also known as USB MSC or UMS) is a set of computing communications protocols, specifically a USB Device Class, defined by the USB Implementers Forum that makes a USB device accessible to a host computing device and enables file transfers between the host and the USB device. To a host, the USB device acts as an ...
There are eight different UDMA modes, ranging from 0 to 6 for ATA (0 to 7 for CompactFlash), each with its own timing. 80-conductor cable used for modes faster than UDMA 2 on the left compared to a 40-conductor cable. Modes faster than UDMA mode 2 require an 80-conductor cable to reduce data settling times, lower impedance and reduce crosstalk. [1]