enow.com Web Search

  1. Ad

    related to: fuel pump won't start with ignition cylinder and water

Search results

  1. Results from the WOW.Com Content Network
  2. Dieseling - Wikipedia

    en.wikipedia.org/wiki/Dieseling

    The vast majority of vehicles manufactured after 1987 are fuel-injected: the injectors and high-pressure fuel pump immediately cease supplying fuel to the cylinders when the ignition is switched off. If the injector is damaged or dirty, a small amount of fuel can enter the chamber and be ignited, causing a sputter or two after the engine is ...

  3. Fuel pump - Wikipedia

    en.wikipedia.org/wiki/Fuel_pump

    Since the electric pump does not require mechanical power from the engine, it is feasible to locate the pump anywhere between the engine and the fuel tank. The reasons that the fuel pump is typically located in the fuel tank are: By submerging the pump in fuel at the bottom of the tank, the pump is cooled by the surrounding fuel

  4. Crankshaft position sensor - Wikipedia

    en.wikipedia.org/wiki/Crankshaft_position_sensor

    The first sign of crankshaft sensor failure, usually, is the refusal of the engine to start when hot but will start again once the engine has cooled. One detail of some designs is the "three-wire" inductive crank sensor whereby the third wire is actually just a co-axial shield around the two main sensor wires to prevent them from picking up ...

  5. Flooded engine - Wikipedia

    en.wikipedia.org/wiki/Flooded_engine

    A flooded engine is an internal combustion engine that has been fed an excessively rich air-fuel mixture that cannot be ignited. [1] This is caused by the mixture exceeding the upper explosive limit for the particular fuel. An engine in this condition will not start until the excessively rich mixture has been cleared. [2]

  6. Injection pump - Wikipedia

    en.wikipedia.org/wiki/Injection_pump

    Injection pump for a 12-cylinder diesel engine An injection pump is the device that pumps fuel into the cylinders of a diesel engine . Traditionally, the injection pump was driven indirectly from the crankshaft by gears, chains or a toothed belt (often the timing belt ) that also drives the camshaft .

  7. Digifant engine management system - Wikipedia

    en.wikipedia.org/wiki/Digifant_Engine_Management...

    A Digifant II DF-1 Engine Control Unit used in '91 Volkswagen Golf Cabriolet with 2E engine. Digifant is an Engine Management System operated by an Engine Control Unit that actuates outputs, such as fuel injection and ignition systems, using information derived from sensor inputs, such as engine speed, exhaust oxygen and intake air flow. [1]

  8. Diesel engine runaway - Wikipedia

    en.wikipedia.org/wiki/Diesel_engine_runaway

    Diesel engine runaway is an occurrence in diesel engines, in which the engine draws extra fuel from an unintended source and overspeeds at higher and higher RPM, producing up to ten times the engine's rated output until destroyed by mechanical failure or bearing seizure due to a lack of lubrication. [1]

  9. Hydrolock - Wikipedia

    en.wikipedia.org/wiki/Hydrolock

    Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine. This is just as damaging as it is to internal combustion engines and in the case of a steam locomotive can be very dangerous as a broken connecting rod could puncture the firebox ...

  1. Ad

    related to: fuel pump won't start with ignition cylinder and water