Search results
Results from the WOW.Com Content Network
The 1982 L83 was again the only Corvette engine, producing 200 hp (149 kW) and 285 lb⋅ft (386 N⋅m) of torque from 9.0:1 compression. Since GM did not assign a 1983 model year to production Corvettes, there was no L83 for 1983. [22] This was also the only engine on the 1984 Corvette, at 205 hp (153 kW) and 290 lb⋅ft (393 N⋅m) of torque.
LS2 can also refer to the 1973–1974 Super Duty 455 cu in (7.5 L) Pontiac V8 engine LS2 can also refer to the 1985 Oldsmobile Diesel V6 engine. The LS2 was introduced as the Corvette's new base engine for the 2005 model year. It also appeared as the standard powerplant for the 2005–2006 GTO.
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
Corvette concept cars have inspired the designs of several generations of Corvettes. [43] The first Corvette, Harley Earl's 1953 EX-122 Corvette prototype was itself, a concept show car, first shown to the public at the 1953 GM Motorama at the Waldorf-Astoria Hotel in New York City on January 17, 1953. It was brought to production in six months ...
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
The National Corvette Museum showcases the Chevrolet Corvette, an American sports car that has been in production since 1953. It is located in Bowling Green, Kentucky , off Interstate 65 's Exit 28 and near General Motors ' Bowling Green Assembly Plant , where Corvettes are manufactured.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The 1967 Corvette Sting Ray was the last Corvette of the second generation, and five years of refinements made it the best of the line. Although it was meant to be a redesign year, its intended successor the C3 was found to have some undesirable aerodynamic traits. Duntov demanded more time in the wind tunnel to devise fixes before it went into ...