Search results
Results from the WOW.Com Content Network
T-tails were common in early jet aircraft. Designers were worried that an engine failure would otherwise damage the horizontal tail. The T-tail is very common on aircraft with engines mounted in nacelles on a high-winged aircraft or on aircraft with the engines mounted on the rear of the fuselage, as it keeps the tail clear of the jet exhaust.
Aircraft flight mechanics are relevant to fixed wing (gliders, aeroplanes) and rotary wing (helicopters) aircraft.An aeroplane (airplane in US usage), is defined in ICAO Document 9110 as, "a power-driven heavier than air aircraft, deriving its lift chiefly from aerodynamic reactions on surface which remain fixed under given conditions of flight".
The empennage of an Atlas Air Boeing 747-200. The empennage (/ ˌ ɑː m p ɪ ˈ n ɑː ʒ / or / ˈ ɛ m p ɪ n ɪ dʒ /), also known as the tail or tail assembly, is a structure at the rear of an aircraft that provides stability during flight, in a way similar to the feathers on an arrow.
Pages in category "T-tail aircraft" The following 200 pages are in this category, out of approximately 394 total. This list may not reflect recent changes.
Sonex The original model, incorporating a low-wing design, seats two, and a conventional tail. Available as plans or a kit. [4] [12]Sonex B Introduced in April 2016, this model is a modification of the original Sonex, with an enlarged cockpit for larger and taller pilots, a center "Y-stick", electric flaps and dual throttles as standard.
Normal flight (above), Deep stall condition - T-tail in "shadow" of wing (below) A Schweizer SGS 1-36 being used for deep-stall research by NASA over the Mojave Desert in 1983. A deep stall (or super-stall) is a dangerous type of stall that affects certain aircraft designs, notably jet aircraft with a T-tail configuration and rear-mounted ...
The notion that upright walking and tail loss were functionally linked, with tail muscles being repurposed as pelvic floor muscles, “is an old idea that is NOT consistent with the fossil record ...
In February 1976, work commenced to automate the methods contained in the USAF Stability and Control DATCOM, specifically those contained in sections 4, 5, 6 and 7.The work was performed by the McDonnell Douglas Corporation under contract with the United States Air Force in conjunction with engineers at the Air Force Flight Dynamics Laboratory in Wright-Patterson Air Force Base.