Search results
Results from the WOW.Com Content Network
Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.
Most fixed-wing aircraft have a trimming control surface on the elevator, but larger aircraft also have a trim control for the rudder, and another for the ailerons. The rudder trim is to counter any asymmetric thrust from the engines. Aileron trim is to counter the effects of the centre of gravity being displaced from the aircraft centerline ...
a servo tab used to move the main control surface, as well as act as a trim tab. Usually controlled by a cockpit wheel or crank. [5] Multi-engined aircraft often have trim tabs on the rudder to reduce the pilot effort required to keep the aircraft straight in situations of asymmetrical thrust, such as single engine operations. [7]
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...
On many aircraft, the tailplane assembly consists of a fixed surface fitted with a hinged aft elevator surface. Trim tabs may be used to relieve pilot input forces. Alternatively, some light aircraft such as the Piper PA-24 Comanche and the Piper PA-28 Cherokee have an all-moving stabilizer known as a stabilator, with no separate elevator ...
Elevators' effect on pitch Elevator and pitch trim tab of a light aircraft. Elevators are flight control surfaces, usually at the rear of an aircraft, which control the aircraft's pitch, and therefore the angle of attack and the lift of the wing. The elevators are usually hinged to the tailplane or horizontal stabilizer.
An aircraft 'rolling', or 'banking', with its ailerons An aileron and roll trim tab of a light aircraft. An aileron (French for "little wing" or "fin") is a hinged flight control surface usually forming part of the trailing edge of each wing of a fixed-wing aircraft. [1]
The vertical stabilizer is the fixed vertical surface of the empennage. A vertical stabilizer or tail fin [1] [2] is the static part of the vertical tail of an aircraft. [1] The term is commonly applied to the assembly of both this fixed surface and one or more movable rudders hinged to it.