enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   Left: Generic 8P8C (or 8PMJ, 8-position modular jack) male connector. Right: 8P8C male connector with key, which mates with RJ41S, RJ45S, and RJ48S. Although commonly referred to as RJ45 in the context of Ethernet and structured cabling, RJ45 originally referred to a specific wiring configuration of an 8P8C female connector.

3. EtherCON - Wikipedia

   en.wikipedia.org/wiki/EtherCON

   The chassis connector is always female and has the standard form factor of an XLR panel connector. The chassis connector may be mated with an EtherCON connector and a standard 8P8C plug. The chassis connectors are rated for either Cat 5e, Cat 6 or 6A compatibility, with the Cat 5e and 6A models being cross-compatible. (The Cat 6 model utilizes ...

4. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   Cross section of a cat 5e cable. The Category 5e specification improves upon the Category 5 specification by further mitigating crosstalk. [9] The bandwidth (100 MHz) and physical construction are the same between the two, [10] and most Cat 5 cables actually happen to meet Cat 5e specifications even though they are not certified as such. [11]

5. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   This is surrounded by a circular shroud on the male connector, which fits into a matching recess on the female connector. The standard defines connectors with 3, 4 and 5 pins, but a non-standard variant with 7 pins (6 in a circle plus one in the centre) is commercially available; [ 6 ] this can be used for star-delta starting of three-phase motors.

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Bullet terminals, male and female (right-center, with blue wires) A blade connector is a type of single wire, plug-and-socket connection device using a flat conductive blade (plug) that is inserted into a receptacle. Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and ...

7. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   The micro ribbon connector, first made by Amphenol, that is used in the RJ21 interface, has also been used to connect Ethernet ports in bulk from a switch with 50-pin ports to a Cat-5 rated patch panel, or between two patch panels. A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a ...