Search results
Results from the WOW.Com Content Network
Some types of residential elevators do not use a traditional elevator shaft, machine room, and elevator hoistway. This allows an elevator to be installed where a traditional elevator may not fit, and simplifies installation. The ASME board first approved machine-room-less systems in a revision of the ASME A17.1 in 2007.
Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...
If the service core (which contains the elevator shafts) becomes too big, it can reduce the profitability of the building. Architects must therefore balance the value gained by adding height against the value lost to the expanding service core. [10] Many tall buildings use elevators in a non-standard configuration to reduce their footprint.
Because of the building's height, it was deemed infeasible to have many elevators or large elevator cabins, so the builders contracted with the Otis Elevator Company to make 66 cars that could speed at 1,200 feet per minute (366 m/min), which represented the largest-ever elevator order at the time. [234]
Guide rails are part of the inner workings of most elevator and lift shafts, functioning as the vertical, internal track. The guide rails are fixed to two sides of the shaft; one guides the elevator car and the other for the counterweight.
A simple dumbwaiter is a movable frame in a shaft, dropped by a rope on a pulley, guided by rails; most dumbwaiters have a shaft, cart, and capacity smaller than those of passenger elevators, usually 45 to 450 kg (100 to 992 lbs.) [2] Before electric motors were added in the 1920s, dumbwaiters were controlled manually by ropes on pulleys.
Double-deck elevators at Midland Square, Nagoya, Japan The Bailong Elevator Symbol seen within the upper cabin of the elevator in Roppongi Hills Mori Tower Double lobby ("lower lobby" and "upper lobby") to enter the elevators in Roppongi Hills Mori Tower. A double-deck elevator or double-deck lift is an elevator where one cab is stacked on top ...
This is a standardised measure of the maximum difference in size between the component and the basic size (see below). For example, if a shaft with a nominal diameter of 10 mm is to have a sliding fit within a hole, the shaft might be specified with a tolerance range from 9.964 to 10 mm (i.e., a zero fundamental deviation, but a lower deviation ...