Search results
Results from the WOW.Com Content Network
Two-inch port tube installed in the top of a Polk S10 speaker cabinet as part of a DIY audio project. This port is flared. Unlike closed-box loudspeakers, which are nearly airtight, a bass reflex system has an opening called a port or vent cut into the cabinet, generally consisting of a pipe or duct (typically circular or rectangular cross section).
These designs can be considered a mass-loaded transmission line design or a bass reflex design, as well as a quarter wave enclosure. [39] Quarter wave resonators have seen a revival as commercial applications with the onset of neodymium drivers that enable this design to produce relatively low bass extensions within a relatively small speaker ...
The name IMF was adopted because Bud Fried had demonstrated the first prototype speakers at the New York hi fi show, and because of the publicity and the fact that he had used his name on the then unnamed speakers, we stuck with the name which was a mistake on our part. It was never his company. After our lawsuit he called his speakers Fried. [7]
This article lists manufacturers of bass amplifiers, loudspeakers, and other amplification-related items such as preamplifiers. The amplifiers and loudspeakers used to amplify bass instruments (e.g., the bass guitar, double bass and similar instruments) are distinct from other types of amplification systems due to the particular challenges associated with low-frequency sound reproduction.
Passive radiators are used instead of a reflex port for several reasons. In small-volume enclosures tuned to low frequencies, the length of the required port becomes very large. [5] They are also used to reduce or eliminate the objectionable noises of port turbulence and compressive flow caused by high-velocity airflow in small ports.
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
The two most common types of speaker enclosure are acoustic suspension (sometimes called pneumatic suspension) and bass reflex.In both cases, the tuning affects the lower end of the driver's response, but above a certain frequency, the driver itself becomes the dominant factor and the size of the enclosure and ports (if any) become irrelevant.
An isobaric loudspeaker is a loudspeaker in which two or more identical woofers (bass drivers) operate simultaneously, with a common body of enclosed air adjoining one side of each diaphragm. They are most often used to improve low-end frequency response without increasing cabinet size, though at the expense of cost and weight.