Search results
Results from the WOW.Com Content Network
While the outward designs of apparatuses can vary greatly, most apparatuses use a sample loaded into a sealed capillary tube (melting-point tube), which is then placed in the apparatus. The sample is then heated, either by a heating block or an oil bath, and as the temperature increases, the sample is observed to determine when the phase change ...
The Joback method, often named Joback–Reid method, predicts eleven important and commonly used pure component thermodynamic properties from molecular structure only. It is named after Kevin G. Joback in 1984 [1] and developed it further with Robert C. Reid. [2] The Joback method is an extension of the Lydersen method [3] and uses very similar groups, formulas, and parameters for the three ...
Thermogravimetric analysis or thermal gravimetric analysis (TGA) is a method of thermal analysis in which the mass of a sample is measured over time as the temperature changes. . This measurement provides information about physical phenomena, such as phase transitions, absorption, adsorption and desorption; as well as chemical phenomena including chemisorptions, thermal decomposition, and ...
The benefit of this procedure is the ability to separate overlapping DSC effects by calculating the reversing and the non-reversing signals. The reversing heat flow is related to the changes in specific heat capacity (→ glass transition) while the non-reversing heat flow corresponds to time-dependent phenomena such as curing, dehydration and ...
The melting point (or, rarely, liquefaction point) of a substance is the temperature at which it changes state from solid to liquid. At the melting point the solid and liquid phase exist in equilibrium. The melting point of a substance depends on pressure and is usually specified at a standard pressure such as 1 atmosphere or 100 kPa.
The Kjeldahl method's universality, precision and reproducibility have made it the internationally recognized method for estimating the protein content in foods and it is the standard method against which all other methods are judged. It is also used to assay soils, waste waters, fertilizers and other materials.
A eutectic system or eutectic mixture (/ j uː ˈ t ɛ k t ɪ k / yoo-TEK-tik) [1] is a type of a homogeneous mixture that has a melting point lower than those of the constituents. [2] The lowest possible melting point over all of the mixing ratios of the constituents is called the eutectic temperature.
While chemically pure materials have a single melting point, chemical mixtures often partially melt at the temperature known as the solidus (T S or T sol), and fully melt at the higher liquidus temperature (T L or T liq). The solidus is always less than or equal to the liquidus, but they need not coincide.