Search results
Results from the WOW.Com Content Network
Device interfaces where one bus transfers data via another will be limited to the throughput of the slowest interface, at best. For instance, SATA revision 3.0 ( 6 Gbit/s ) controllers on one PCI Express 2.0 ( 5 Gbit/s ) channel will be limited to the 5 Gbit/s rate and have to employ more channels to get around this problem.
Four PCI Express bus card slots (from top to second from bottom: ×4, ×16, ×1 and ×16), compared to a 32-bit conventional PCI bus card slot (very bottom). In computer architecture, a bus (historically also called a data highway [1] or databus) is a communication system that transfers data between components inside a computer or between computers. [2]
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
The 24-pin double-sided connector provides four power–ground pairs, two differential pairs for USB 2.0 data (though only one pair is implemented in a USB-C cable), four pairs for SuperSpeed data bus (only two pairs are used in USB 3.1 mode), two "sideband use" pins, V CONN +5 V power for active cables, and a configuration pin for cable ...
Short for Improved Inter-Integrated Circuit, [4] the standard defines the electrical connection between the chips to be a two wire, shared , serial data bus, one wire (SCL) being used as a clock to define the sampling times, the other wire (SDA) being used as a data line whose voltage can be sampled. The standard defines a signaling protocol in ...
Data rate versus line length chart, from RS-422 Annex A.1. Several key advantages offered by this standard include the differential receiver, a differential driver and data rates as high as 10 megabits per second at 12 meters (40 ft). Since the signal quality degrades with cable length, the maximum data rate decreases as cable length increases.
The technology [2] uses two [a] sets of thick, multi-connector copper cables, one [b] set, carrying data, called the bus, and the other set, carrying control information, called the tag. [3] Bus and tag terminator blocks. Bus and Tag cables are "daisy chained"; and one interface can attach up to eight peripheral control units. The last control ...
Generally use coaxial cable types such as RG-6 and RG-59 (except for twin-lead). Belling-Lee/IEC 169-2 connector TV aerial plug (a.k.a. antenna plug) Television antenna connection for most video devices outside North America. Used by early home computers and game consoles to connect them to TVs because of the lack of any other connector.